Diamant Cipollini FLUSSO Panduan Pengoperasian dan Pemeliharaan - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemeliharaan untuk Skuter Diamant Cipollini FLUSSO. Diamant Cipollini FLUSSO 14 halaman.
Halaman Cetak
12
2.4.7.1
SWITCHING ON/OFF THE ASSISTANCE SYSTEM
The assistance system is activated by pressing the power button circled in
the following image.
The assistance system can only be activated if the battery is sufficiently
charged. In addition, the speed sensor must be properly connected to the drive
unit (see engine-specific instructions at
com/en/e-bike-system/bikedrive-air
of inactivity (cycling assistance is not used and no key is pressed) the
assistance system will deactivate. Do not press on the pedals when the pedal-
assisted bicycle is switched on. Start cycling when the bicycle is fully on.
The assistance system is switched off by keeping the power button pressed
for about 4 seconds.
https:/ /www.maxonbikedrive.
if in doubt). After a long period
2.4.7.2
ADJUSTING THE LEVEL OF ASSISTANCE
On the controller, you can set the e-Bike engine assistance level while
pedalling. The level of assistance can be changed at any time, even while
moving. There are 4 levels of assistance available:
• LEVEL 0: the engine assistance is deactivated; it is possible to operate the
pedal-assisted bicycle by pedalling as on a normal push bicycle. With this
level of assistance, the impetus aid cannot be activated.
• LEVEL 1: active assistance at the highest level of efficiency, for maximum
autonomy.
• LEVEL 2: uniform level assistance, for long-distance excursions.
• LEVEL 3: maximum level assistance, up to high pedalling frequencies, for
athletic use.
The selected layer is visible in the image below on the controller or on the
computer loop attached to it.
13
#LiveYourRide