Miller BOBCAT 225G PLUS Panduan Pemilik - Halaman 27

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller BOBCAT 225G PLUS. Miller BOBCAT 225G PLUS 40 halaman.

Halaman Cetak
C. Engine
Trouble
Engine will not crank.
Engine will not start.
Engine starts but stops when Engine
Control switch returns to Run position.
Engine stopped during normal
operation.
Battery discharges between uses.
Engine idles but does not come up to
weld speed.
Unstable or sluggish engine speeds.
Engine does not return to idle speed.
Check fuse F6, and replace if open (see Section 6-6).
Check battery voltage.
Check battery connections and tighten if necessary.
Check plug PLG4 and plug PLG8 connection.
Have Factory Authorized Service Agent check Engine Control switch S2.
Check fuel level.
Check battery voltage.
Check battery connections and tighten if necessary.
Check oil level. Check low oil pressure shutdown switch S5 (see Section 3-4 and Parts List).
Have Factory Authorized Service Agent check optional fuel shutoff solenoid FS1.
Check oil level. Check low oil pressure shutdown switch S5 (see Section 3-4 and Parts List).
Check and refill crankcase with proper viscosity oil for operating temperature, if necessary.
Check fuel level.
Check oil level. Check low oil pressure shutdown switch S5 (see Section 3-4 and Parts List).
Periodically recharge battery (approximately every 3 months).
Replace battery.
Check voltage regulator and connections according to engine manual.
Have Factory Authorized Service Agent check optional fuel shutoff solenoid FS1.
Clean battery, terminals, and posts with baking soda and water solution; rinse with clear water.
Periodically recharge battery (approximately every 3 months).
Replace battery.
Check voltage regulator and connections according to engine manual.
Have Factory Authorized Service Agent check auto idle module PC1 and current transformer CT1.
Readjust throttle linkage if necessary. Check throttle solenoid TS1 for smooth operation.
Tune-up engine according to engine manual.
Remove weld and auxiliary power loads.
Check throttle linkage for smooth, non-binding operation.
Have Factory Authorized Service Agent check idle module PC1, Engine Control switch S2, and throttle
solenoid TS1.
Remedy
OM-403 Page 23