Miller Copilot Panduan Pemilik - Halaman 25
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller Copilot. Miller Copilot 48 halaman. Collaborative welding system
Halaman Cetak
5-3.
Leveling The System
Raising Leveling Mounts
2
1
Lowering Leveling Mounts
trashcan
2
1
level
wrench
crescent wrench
tape measure
nutdriver
chippinghammer
wirecutter
frontcutter
gear puller
3
3
continuitytester
Grinder left
Drum
scraper
crow-foot wrench
Wooden Wedge
Grinding Wheel
1 Leveling Mount
2 5/8 in. (16 mm) Jam Nut
3 Wheel
Leveling the system is recommended.
Lowering Leveling Mounts For Welding
Operation
Spin leveling mount down until it contacts
the floor.
Using wrench, continue to spin the leveling
mount until cart is raised off the wheels. Do
not raise wheels by more than 0.75 in. (19
mm).
Repeat on all four corners. Check the table
level and adjust as required to level table.
Use wrench to secure 5/8 in. jam nuts.
NOTICE – Cart must be supported by level-
ing mounts to support rated load of 1500 lb
(680 kg).
Raising Leveling Mounts For Transit
Remove tooling from cart before transit.
tools/
Maximum transit load is 750 lb (340 kg).
Loosen 5/8 in. jam nut enough to allow rais-
ing of leveling mount.
Spin leveling mount to raise it off the floor by
at least 1/4 in. (6 mm). Do not raise mounts
past 1 inch (25 mm).
Repeat on all four corners.
Grinder right
IGBT tester
greenlee knockout
punch
Dressing Tool
Safety shoe
PAPR
Respirator
Phillips #2 bit
Hard hat
OM-291865 Page 21
Drift pin
Torx socket