Miller PipePro Single DX Feeder OM-230 010F Panduan Pemilik - Halaman 25
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller PipePro Single DX Feeder OM-230 010F. Miller PipePro Single DX Feeder OM-230 010F 48 halaman.
Halaman Cetak6-5. Program Push Button
6-6. Upper Display
1
4
1
Upper Display
The upper display shows voltage/trim or
time. The unit displays both preset and actu-
al arc voltage. When the unit is in a welding
state, actual arc voltage is displayed. The
upper display shows welding sequence time
when the Time LED is illuminated.
2
Upper Display Push Button
Press and hold button to adjust or display
weld time. Release button to display voltage/
trim.
3
Upper Display Push Button LED
The upper display push button LED illumi-
nates to indicate that information displayed
1
Program
2
V/Trim
Time (sec)
can be changed by the Adjust control.
4
Volts/Trim LED
5
Time LED
The LEDs below the display illuminate to in-
dicate which value is being shown.
At any time while welding, the unit permits
the adjustment of the weld sequence voltage
while continuing to display actual arc volt-
age.
• If the unit is displaying a welding sequence
that can be timed, the welding time display
mode is entered by pressing the upper dis-
play push button repeatedly until welding
3
5
time is the active parameter in the upper
display. At idle, the upper display toggles
between showing weld voltage/trim or
weld time, with subsequent presses of the
upper display push button.
• The unit defaults to displaying welding
voltage/trim when a welding sequence
display mode is first entered.
• If the weld sequence has a time set (as in
spot time) and the trigger is held, after the
weld program is completed, ERR TRG 1
will be displayed to indicate the weld pro-
gram is complete. Release trigger to clear
error.
1
Program Display
The number of the active program
is displayed.
2
Program Push Button
Press button to activate program
select feature. To change the pro-
gram number, press the Program
push button and rotate the Adjust
control.
3
Program Push Button LED
The LED lights to indicate the Pro-
gram push button is active.
3
2
OM-230 010 Page 21