Miller SUBARC WIRE DRIVE 400 T CE Panduan Pemilik - Halaman 14
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller SUBARC WIRE DRIVE 400 T CE. Miller SUBARC WIRE DRIVE 400 T CE 28 halaman.
Halaman Cetak
4-1. Description
.
Motor shown without feed roller guard.
4-2. Serial Number And Rating Label Location
The serial number and rating information for this product is located on the motor body. Use rating label to determine input power requirements and/or
rated output. For future reference, write serial number in space provided on back cover of this manual.
4-3. Specifications
Wire Feed
Model
30 To 400 ipm
SubArc Wire Drive 400T
(0.8 To 10
Digital Low Voltage
4-4. Environmental Specifications
A. IP Rating
This equipment is designed for outdoor use. It may be stored, but is not intended to be used for welding outside during precipitation unless
sheltered.
B. Information On Electromagnetic Fields (EMF)
!
This equipment shall not be used by the general public as the EMF limits for the general public might be exceeded during welding.
This equipment is built in accordance with EN 60974−1 and is intended to be used only in an occupational environment (where the general public
access is prohibited or regulated in such a way as to be similar to occupational use) by an expert or an instructed person.
Wire feeders and ancillary equipment (such as torches, liquid cooling systems and arc striking and stabilizing devices) as part of the welding
circuit may not be a major contributor to the EMF. See the Owner's Manuals for all components of the welding circuit for additional EMF exposure
information.
S
The EMF assessment on this equipment was conducted at 0.5 meter.
S
At a distance of 1 meter the EMF exposure values were less than 20% of the permissible values.
C. Information On Electromagnetic Compatibility (EMC)
!
This Class A equipment is not intended for use in residential locations where the electrical power is provided by the public low−
voltage supply system. There can be potential difficulties in ensuring electromagnetic compatibility in those locations, due to con-
ducted as well as radiated disturbances.
OM-253789 Page 10
SECTION 4 − SPECIFICATIONS
Wire Diameter
Speed
Range
Range
3/32 To 3/16 in.
(2.4 To 4.8 mm)
mpm)
1
Input Weld
Rating
Circuit Rat-
ing
100 Volts
1/5 HP
1000 Amperes
100% Duty
85 RPM
Cycle
IP Rating
IP2X
1
Motor/drive Assembly
This unit is a heavy-duty wire feed-
ing motor/drive assembly designed
for automated Submerged Arc
Welding (SAW) applications.
Ref. 265710-A
Type Of
Input
Input
Power
Power
Cord
48 in.
38 VDC
(1.22 m)
ce-emf 1 2010-10
ce-emc 3 2014-07
Weight
24 lb
(11 kg)
IP2X 2014−06