Miller SuitCase X-TREME 8VS Non-CE Panduan Pemilik - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller SuitCase X-TREME 8VS Non-CE. Miller SuitCase X-TREME 8VS Non-CE 40 halaman.
Juga untuk Miller SuitCase X-TREME 8VS Non-CE: Panduan Pemilik (40 halaman), Panduan Pemilik (40 halaman)
Halaman Cetak
5-1. Equipment Connection Diagram
1
2
3
4
5
Notes
OM-262379 Page 12
SECTION 5 − INSTALLATION
10
9
8
7
6
!
Turn Off wire feeder and
welding power source. Stop
engine on welding
generator.
!
Do not move or operate
equipment where it could
tip.
!
Use only with CC/CV DC
Power Sources.
1
Constant Current (CC) or
Constant Voltage (CV)
Welding Power Supply
2
Weld Cable To Feeder
3
Work Cable To Workpiece
Weld cable and work cable connec-
tions to power source (DCEN/
DCEP) are dependant on wire type.
.
Since feeder is not polarity sen-
sitive, there is no need for an
electrode polarity switch.
4
Workpiece
5
Voltage Sensing Clamp
Connect voltage sensing clamp to
workpiece.
6
Gun
7
Gun Trigger Receptacle
8
Wire Feeder
9
Gas Hose
10 Gas Cylinder
Use of shielding gas is dependant
on wire type.
.
Shielding gas pressure not to
exceed 100 psi (689 kPa).
Ref. 265 366-A