Miller Syncrowave 351 Panduan Pemilik - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller Syncrowave 351. Miller Syncrowave 351 42 halaman. Arc welding power source

Halaman Cetak

3-3. Volt-Ampere Curves

A. DC Mode
*During low arc voltage conditions (short arc length), increasing
Arc Control setting increases amperage (see Section 4-2).

3-4. Dimensions and Weights / Selecting A Location

Movement
Location And Airflow
1
3
*
1
OR
18 in (460
mm)
B. AC Mode
Net Weight: 541 lb (245 kg), Length:
22-1/2 in (577 mm), Width: 24 in
(577 mm), Height: 44 in (1,218 mm)
with retractable lifting eye down.
1
2
Use lifting eye or lifting forks to
move unit.
If using lifting forks, extend forks
beyond opposite side of unit.
2
3
4
6
Use rating label to determine input
power needs. CE label located on
rear panel.
5
6
4
5
Locate unit near correct input pow-
er supply.
Y Special installation may be
18 in (460
mm)
The volt-ampere curves show the
minimum and maximum voltage
and amperage output capabilities of
the welding power source. Curves
of other settings fall between the
curves shown.
ssb1.1 10/91 – ST-159 286 / ST-159 285
Lifting Eye
Lifting Forks
Rating Label (Non CE Models
Only)
Rating Label (CE Models
Only, See Section 2-2)
Plate Label (CE Models Only)
Line Disconnect Device
required where gasoline or
volatile liquids are present –
see NEC Article 511 or CEC
Section 20.
ST-800 402 / ST-117 264-C
TM-354 Page 13