Miller XMT 304 Panduan Pemilik - Halaman 25
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller XMT 304. Miller XMT 304 40 halaman. 4-rack and 6-rack
Juga untuk Miller XMT 304: Panduan Pemilik (26 halaman), Panduan Pemilik (37 halaman)
Halaman Cetak
5-7. Connecting 3-Phase Input Power (Continued)
!
Installation must meet all National and
Local Codes − have only qualified per-
sons make this installation.
!
Disconnect and lockout/tagout input
power before connecting input con-
ductors from unit. Follow established
procedures regarding the installation
and
removal
of
lockout/tagout
devices.
!
Always connect green or green/yellow
conductor to supply grounding termi-
nal first, and never to a line terminal.
See rating label on unit and check input volt-
age available at site.
Notes
NOTICE − The Auto-Link circuitry in this unit
automatically links the power source to the
primary voltage being applied. A 230/460 unit
can be connected to either 230 or 460 VAC in-
put power. A 460/575 model can be con-
nected to either 460 or 575 VAC input power.
For Three-Phase Operation
1
Input Power Cord.
2
Disconnect Device (switch shown in the
OFF position)
3
Green Or Green/Yellow Grounding
Conductor
4
Disconnect Device Grounding Terminal
5
Input Conductors (L1, L2 And L3)
6
Disconnect Device Line Terminals
Connect green or green/yellow grounding
conductor to disconnect device grounding ter-
minal first.
Connect input conductors L1, L2, and L3 to
disconnect device line terminals.
7
Over-Current Protection
Select type and size of over-current protec-
tion using Section 5-5 (fused disconnect
switch shown).
Close and secure door on disconnect device.
Follow established lockout/tagout procedures
to put unit in service.
OM-2208 Page 21
input2 2012−05