Miller XR - Pistol - Pro Panduan Pemilik - Halaman 19
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller XR - Pistol - Pro. Miller XR - Pistol - Pro 40 halaman. Air and water-cooled gun
Halaman Cetak5-10. Threading Welding Wire Through Gun
!
Welding wire is electrically live when
gun trigger is used to jog wire.
.
Turn OFF coolant supply before removing
head tube on water-cooled gun.
JOG / PURGE
Tools Needed:
Refer to wire feeder manual for instructions on
feeding wire through feeder.
1
Cut off wire. Close and latch
wire feeder door.
1
Pressure Arm Lever
.
To release drive roll pressure,
pull back on pressure arm lever.
While pulled back, shift to left
onto shoulder to lock into place.
Lay gun cable out straight. Press Jog switch
until about 6 in. (152 mm) of wire is sticking
out end of contact tip.
.
Verify pressure adjustment
on handle matches the wire
type. See Section 6-2.
Ref. T0006 / T0022 / T0023
OM-254 824 Page 15