aquantica at2i Panduan Pengoperasian - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Aksesori Kamera aquantica at2i. aquantica at2i 16 halaman. For the canon t2i

Of the Latches:

The two latches of the AQUATICA Pro Digital are designed to have a locking action to prevent accidental opening.Always

ensure that the locking mechanism is secure. Watch for the build-up of corrosion or salt residue around the latches. This

will appear as a white material. Lubricate the latches with a small amount of WD-40 to remove the corrosion

or salt residue build-up.

Of the O-Rings:

The O-rings that need to be maintained on a regular basis are the main housing O-ring and the port and extension O-rings.

Theses O-rings should be cleaned and inspected on a daily basis and each time the port is changed.

Of the sacriﬁcial anodes:

The anode attached to the bottom part of the housing is there to prevent corrosion due to electrolysis, as time

goes it will deteriorates and need to be replaced, contact your dealer for replacement kit. (parts # 19220).

TO SERVICE O-RINGS ON THE HOUSING MAIN O-RING, PORTS AND EXTENSION RINGS

Removing the O-ring. It is important never to use a sharp instrument when removing an O-ring as this may

damage the O-ring groove or the O-ring itself. A bobby pin or edge of a credit card works well. the main body

O-ring groove has a starting point in the lower left corner in which a dulled point can be inserted to remove it.

Once the O-ring is removed, it should be examined for damage. Check to make sure that the O-ring is free of

nicks and cuts and that it retains its original round proﬁle. O-rings that appear to be damaged should be discarded

immediately and replaced with new O-rings.

Rinse the O-ring with fresh water and dry it with a clean lint free cloth.

Clean the O-ring groove (where the O-ring sits) with a Q-tip. Be sure to remove any lint the Q-tip may leave

behind. Inspect the groove for damage.

Wipe the part of the housing that the O-ring seals against with a clean lint-free cloth.

Re-grease the O-ring with a thin layer of O-ring grease until it appears to be smooth and shiny. Do not over

grease it. Use just enough grease so the O-ring will pull smoothly through your ﬁngers. Excessive amounts of

grease will only serve to attract dirt to the o-ring.

Make sure that the O-ring is properly (envenly) installed in the O-ring groove.

To reinstall the clean and lubricated O-ring, place the entire O-ring over the groove and start by pushing theO-ring

in at each corner then, push the O-ring at each side and ﬁnally, work in the rest of the O-ring. Never start at one

end and work your way around the O-ring. This places uneven tension on the O-ring which may cause the O-ring

to stretch resulting in excess O-ring, which will have no place to go.

There are internal O-rings on the housing controls as well. These O-rings are not as susceptible to damage as they are

not exposed but they do require yearly maintenance and are not user serviceable. The housing should be returned to

an authorized AQUATICA service facility for this annual maintenance. Check for the closest service center on our website

www.aquatica.ca.

An internal moisture alarm can be installed in your AQUATICA AT2i Digital housing (Product # 20023). This moisture

alarm is powered by an easily replaceable CR 2032 battery. Please read the instruction sheet provided for your moisture

alarm prior to installing the battery.

page 12