Miller XR-Pistol-Plus Panduan Pemilik - Halaman 20

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller XR-Pistol-Plus. Miller XR-Pistol-Plus 32 halaman. Air and water-cooled guns

Halaman Cetak
Miller XR-Pistol-Plus Panduan Pemilik

7-4. Gun Drive Assembly Maintenance

Tools Needed:
7/64, 1/16 in.
3/8 in.
OM-248663 Page 16
2
3
1
Lever Arm
Remove pressure on wire by
pulling lever arm forward. Pull to left
to lock into place.
Retract wire onto spool.
2
Drive Roll
Use wire brush to clean drive roll.
Install drive roll with hex opening
down toward shaft hex, and secure
with screw.
3
Pressure Roll
Thread welding wire through gun.
Engage feeder drive rolls. Press jog
switch until wire is sticking out end
of contact tip.
Close top cover.
1
Ref. T0008-A