Miller XT30 Panduan Pemilik - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pengelasan Miller XT30. Miller XT30 40 halaman. Air plasma cutting and gouging
Juga untuk Miller XT30: Panduan Pemilik (44 halaman)

Halaman Cetak
Miller XT30 Panduan Pemilik

4-4. Duty Cycle And Overheating

3-1/2 Minutes Cutting
Overheating

4-5. Environmental Specifications

IP Rating
This equipment is designed for outdoor use. It may be stored, but is
not intended to be used outside during precipitation unless sheltered.
.
A complete Parts List is available at www.MillerWelds.com
20% duty cycle
2 Minutes Cutting
35% duty cycle
0
15
Minutes
IP23CS
8 Minutes Resting
6-1/2 Minutes Resting
Operating Temperature Range
5 to 104 F (−15 to 40 C)
Duty Cycle is percentage of 10
minutes that unit can cut at rated
load without overheating.
If unit overheats, thermostat(s)
opens, output stops, Temperature
trouble light goes On, and cooling
fan runs. Wait fifteen minutes for
unit to cool or temperature light to
go off. Reduce amperage or duty
cycle before cutting or gouging.
NOTICE − Exceeding duty cycle
can damage unit and void warranty.
A
OR
Reduce Duty Cycle
sduty1 5/95 / Ref. 804 503-A
OM-253 555 Page 13