Miller Travel Master SB-10D Panduan Pemilik - Halaman 20

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Aksesori Pengelasan Miller Travel Master SB-10D. Miller Travel Master SB-10D 44 halaman. Automatic welding sidebeam

Halaman Cetak
Travel Right
Switch Position
Connect To Terminal F
On Terminal Strip 2T
Connect To
Terminal D
On Terminal
Strip 1T
Connect To
Terminal F
On Terminal
Strip 1T
Connect To
Terminal G
On Terminal
Strip 1T
Figure 5-2. Switch Installation For Remote Travel
Direction Control
To make Remote Travel Direction switch connections,
proceed as follows:
1.
Remove the four screws securing the Carriage
Control to the mounting bracket, and remove the
control from the bracket.
2.
Remove the securing screws from control wrap-
per, and remove wrapper.
3.
Disconnect the two leads connected to the center
two terminals of TRAVEL DIRECTION switch S4,
and secure leads away from switch.
4.
Loosen strain relief clamp on rear of control, and
route switch leads through clamp to terminal
strips 1T and 2T.
5.
Connect one pole of switch as follows (see Figure
5-2):
a. Connect terminal corresponding to movement
right to terminal E on terminal strip 2T.
b. Connect terminal corresponding to movement
left to terminal F on terminal strip 2T.
c. Connect common terminal of switch to terminal
D on terminal strip 1T.
6.
Connect remaining pole of switch as follows (see
Figure 5-2):
d. Connect terminal corresponding to movement
right to terminal F on terminal strip 1T.
e. Connect terminal corresponding to movement
left to terminal E on terminal strip 1T.
f.
Connect common terminal of switch to terminal
G on terminal strip 1T.
OM-889 Page 16
Travel Left
Switch Position
Connect To
Terminal E
On Terminal
Strip 2T
Connect To
Terminal E
On Terminal
Strip 1T
Ref. SA-121 140
7.
Reinstall and secure control wrapper.
8.
Reposition and secure control onto mounting
bracket.
5-5.
REMOTE TRAVEL SPEED CONTROL (Figure
5-3)
WARNING: Read and follow safety informa-
tion at beginning of Section 5-1 before pro-
ceeding.
It is recommended that a 10k ohm, 2 Watt ten-turn
potentiometer be used for remote travel speed control.
The potentiometer must be installed to terminal strip 2T
inside the Carriage Control. When the Remote Travel
Speed control is installed, the front panel TRAVEL
SPEED control R4 is disabled.
To make control connections, proceed as follows:
1.
Remove the four screws securing the Carriage
Control to the mounting bracket, and remove the
control from the bracket.
2.
Remove the securing screws from control wrap-
per, and remove wrapper.
3.
Locate lead 40 inside the unit (connected to ter-
minal G at terminal strip 2T), and disconnect fric-
tion lugs.
4.
Connect the clockwise (CW) terminal of potenti-
ometer to lead J on terminal strip 2T, and connect
counterclockwise (CCW) terminal (unmarked on
potentiometer) to terminal H on 2T.
5.
Connect wiper terminal to terminal G on 2T.
6.
Reinstall and secure control wrapper.
7.
Reposition and secure control onto mounting
bracket.
CW Terminal – Connect To
Terminal J On Terminal
Strip 2T
CW Terminal – Connect
To Terminal H On
Terminal Strip 2T
Figure 5-3. Remote Travel Speed Control
Installation
Wiper Terminal – Connect
To Terminal G On
Terminal Strip 2T
Ref. SA-121 140