Miller Watertank L Panduan Pemilik - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Aksesori Pengelasan Miller Watertank L. Miller Watertank L 16 halaman. Cooling system
Halaman Cetak
3-1. Connections
GTAW Connections
2
6
3
5
4
GMAW Connections
OM-180 231 Page 4
SECTION 3 − INSTALLATION
7
!
!
1
1
If placing cooling unit on welding power
source, slots are provided in bottom of
unit so it fits over lift-eye.
To prevent overheating, make sure cool-
ing unit is positioned so airflow is not re-
stricted.
NOTICE − If welding power source has
a water valve, do not connect hoses to
water valve. Connect hoses as shown.
2
3
4
Fill tank with coolant. Use table in Section
2-3 to select proper coolant. Keep cool-
ant level full.
5
6
Use switch to turn cooler on and off.
7
Customer to supply and install correct in-
put power plug and matching receptacle.
Operation:
Turn power switch On. Flow indicator
spins to indicate that at least 0.53 qt/min
(0.5 L/min) of coolant is flowing.
Turn off power and disconnect
cooler plug.
Install customer supplied power
plug and receptacle according to
all national, state, and local codes
Lift -Eye
Coolant Out Hose
Coolant In Hose
Coolant Tank Cap
Flow Indicator
Power Switch
Input power cord.
Tools Needed:
5/8 in.
801 190-D / 801 191-D