Diamir Eagle Experience Freeride Pro Panduan Servis - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Servis untuk Peralatan Kebugaran Diamir Eagle Experience Freeride Pro. Diamir Eagle Experience Freeride Pro 20 halaman. Eagle experience freeride pro
Halaman Cetak
5.3.2 Set DIN value at the binding
1. Set the calculated DIN value with the adjustment screw for front DIN value (21) on the scale for adjustment value lateral release (23)
(Pictures 5.3 A/B).
2. Set the calculated DIN value with the adjustment screw for back DIN value (22) on the scale for adjustment value forward release (24)
(Pictures 5.3 C/D).
Picture 5.3 a
5.3.3 Check DIN value setting
We recommend using a ski binding adjustment and testing equipment (ISO 11110).
Check if the measured values of the lateral and forward release correspond to the test parameters in the table 4. If the meas-
ured values differ by +/–15% compared to the test parameters, the settings must be readjusted and checked again.
Procedure in case of non symmetrical release values
It is possible that the lateral release values are different on both sides (no symmetrical). In this case check the boot on its compatibility
and general condition (see chapter 5.1). Furthermore check if the black insert in the toe piece (1) is worn, if needed replace the toe piece.
If the release values are outside the tolerances check the adjustment of the binding to the boot (chapter 5.2) and the settings of the
DIN value again (chapter 5.3.2). If necessary set it properly and recheck. In case the values still are not within the tolerances contact the
manufacturer or distributor.
Additional points to be aware:
• Any alterations to the binding, improper mounting and adjustment or use with non Diamir accessories, increase the risk of non-
release or defective release.
• Boots that do not conform to DIN ISO standard, and worn or damaged boots can have a negative influence on the release. Get your
equipment annually checked by a specialist dealer.
• Settings higher than DIN value 10 are not subject to DIN ISO standards. Settings at these numbers are at your own risk.
• Upon skiers' request and skiers' own risk the DIN values may be increased if accidental pre-releases occur despite correctly set bindings.
6
Check function
6.1
Heel elevator on all levels
Check if the heel elevator (5) properly locks in place and the end piece fits at each level: 1
bindings with gliding technology up to 90° and down to check if the system goes back properly to the starting position.
Picture 6.1 a
Picture 5.3 B
Picture 6.1 B
DIAMIr
Service Manual for specialist dealers
Picture 5.3 c
–4
position. Pictures 6.1 A–D. Also put the
st
th
Picture 6.1 c
11
Picture 5.3 D
Picture 6.1 D
www.diamir.com