Miller 16 CB PLUS 1105 Panduan Operator - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Operator untuk Aksesori Kamera Miller 16 CB PLUS 1105. Miller 16 CB PLUS 1105 16 halaman. Fluid head
Halaman Cetak
Introduction
Thank you for purchasing the CiNX 3/5/7 Fluid head.
An impressive strength to size ratio makes the CiNX Fluid head
ideal for use on feature films, documentaries and high-end
television commercial productions that require mid-payload,
frequent re-rigging and a diverse range of lenses and camera
accessories.
CiNX Fluid head features an Arri type side-loading camera
platform. It is designed to adapt to your needs by having an
100mm Bowl fitted as standard which can be quickly changed
to 150mm bowl or Mitchell Base as optional accessories to suit
your tripod and application.
The Fluid Drag and Counterbalance system was designed
to provide excellent ergonomics and control by offerring
progressive and equal increments of drag and torque to give
ultra-soft starts / stops and perfect diagonal transition. The
controls are located on a single backlit panel and allow the users
a highly functional means of controlling all aspects of the camera
motion.
The CiNX Fluid head will give best performance when used on
a wide range of Miller tripods (including the 100mm bowl Solo,
100mm Sprinter, HD and HDC range of Miller tripods). This will
ensure maximum system compatibility to suit professional
set-ups.
CiNX Fluid head will suit most 100mm, 150mm and Mitchell
base tripods (optional accessories may be required). Please refer
to manufactures' manual for mounting details.
Safety Instructions
Attaching / removing the camera
Please use this manual to familiarise yourself with the operation
of the CiNX Fluid head and observe these instructions to prevent
any damage to your equipment. Ensure that all equipment is
operating correctly and free from defects and damage, please
also ensure that the tripod is steady, secure and that the bowl
is approximately horizontal when attaching the camera. The
operator is responsible for the safe operation of this piece of
equipment.
•
Do not exceed the maximum payload capacity of the Fluid
head.
•
Do not leave the camera unattended on the Fluid head.
•
Do not release the SIDE LOAD LOCK LEVER whilst the
camera is at an angle.
•
Do not adjust the tripod whilst the camera is attached to the
Fluid head.
•
Ensure PAN HANDLE CLAMP and CLAMP NUT is securely
tightened.
•
Apply TILT LOCK when adding/removing equipment from
the camera or when attaching/removing the camera from the
Fluid head.
•
Hold camera securely whilst changing Counterbalance, Pan
Drag or Tilt Drag settings.
•
Hold camera securely whilst adjusting the CLAMP NUT to
level the Fluid head.
4 4