Miller ICE-27T Panduan Pemilik - Halaman 19
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Senter Miller ICE-27T. Miller ICE-27T 36 halaman. Air-cooled torches for plasma arc cutting
Juga untuk Miller ICE-27T: Panduan Pemilik (36 halaman), Panduan Pemilik (38 halaman)
Halaman Cetak
4-11. Serial Number And Rating Label Location
The serial number and rating information for this product is located on the bottom. Use rating label to determine input power requirements and/or rated
output. For future reference, write serial number in space provided on back cover of this manual.
4-12. Connecting Input Power
18 in.
(460 mm)
!
Installation must meet all National
and Local Codes − have only
qualified
persons
make
installation.
!
Special installation may be required
where gasoline or volatile liquids
are present − see NEC Article 511 or
CEC Section 20.
.
The Auto-Line circuitry in this unit
automatically links the power source to
.
A complete Parts List is available at www.MillerWelds.com
!
Do Not cut off power cord connector and rewire. The power cord
connector and plugs will work with standard NEMA receptacles.
Modifying power cord, connector, and plugs will void product
warranty.
(460 mm)
the primary voltage being applied,
either 115 or 230 VAC.
this
For 120 volts AC input power, a 15 or 20
ampere individual branch circuit protected
by time-delay fuses or circuit breaker is
required. For 240 volts AC input power, see
Section 4-8.
1
Power Cord Connector
2
Plug − NEMA Type 5−15P
3
Receptacle − NEMA Type 5−15R
(Customer Supplied)
18 in.
4
Plug − NEMA Type 6−50P
5
Receptacle − NEMA Type 6−50R
(Customer Supplied)
Select plug for power supply receptacle
available at site. Install plug onto power
cord adapter. As threaded collar is tight-
ened, push plug onto adapter until collar is
completely tight.
Connect plug to receptacle.
1
2
3
5
4
804 504-A
OM-225 216 Page 15