Miller MC-80 Panduan Pemilik - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Senter Miller MC-80. Miller MC-80 20 halaman.
Halaman Cetak3-1. Installing Hand-Held Torch
WARNING
ELECTRIC SHOCK can kill.
•
Do not touch live electrical parts.
•
Turn Off cutter, and disconnect input power before
installing torch.
MOVING PARTS can cause injury.
•
Keep away from moving parts.
Significant DC voltage can remain on capacitors in cutter
after unit is Off. Always discharge capacitors according to
cutter's Owner's Manual before installing torch.
Tools Needed:
3/8, 5/8 in
All manuals and user guides at all-guides.com
SECTION 3 – INSTALLATION
Rear Panel
4
Figure 3-1. Installing Hand-Held Torch Into Cutter
HOT PARTS can cause severe burns.
•
Allow cooling period before maintaining or servicing.
Turn Off cutter and remove input
power. Remove top of cutter case.
1
2
1
3
4
Insert hose and leads through boot.
2
3
5
6
Connect hose and leads as shown.
Reinstall top of case.
2
1
5
6
4
swarn8.1* 10/91
Trigger Switch Connector
Gas Hose Connector
Pilot Lead Terminal
Boot
Gas Hose
Pilot Terminal
Ref. ST-800 895 / ST-800 896
OM-1592 Page 3