Miller XT30C Manual - Halaman 14
Jelajahi secara online atau unduh pdf Manual untuk Senter Miller XT30C. Miller XT30C 40 halaman.
Juga untuk Miller XT30C: Panduan Pemilik (40 halaman)
Halaman Cetak
3-1. XT30 Specifications
Torch −
The XT30 torch is intended for handheld use only. The torch conforms to IEC 60974-7 when used with the Spectrum
375X-TREME. Do not use this torch in combination with any other machines.
Gas Type
Gas Quality
Gas Inlet Flow and Pressure
Gas Filtering
Cooling Method
Duty Cycle of Torch
Rating of Electrical Controls (Trigger)
Rating of Electrical Controls (Cup)
Approved Systems
Trigger Protection
Safety Devices
Rated Capacity (edge start)
Sever Cut Capacity (edge start)
Pierce Capacity
*Travel speeds are approximately 80% of maximum.
Weight
Requirements for the torch connection
S
Use only compressed air which is free from dirt, oil, and water.
S
Ensure that the connections are properly assigned and tightened.
S
For torch replacement, see Miller torch manual Part No. OM-1593
S
Ensure correct air pressure (flow pressure) and airflow (volume) are set. Insufficient airflow can lead to the torch overheating.
3-2. XT30 Torch Dimensions
OM-254 449 Page 10
SECTION 3 − SPECIFICATIONS
Spectrum 375 X-TREME w/XT30
3/8 in. at 18 ipm (457 mm/min)*
1-3/16 in.
(30 mm)
Air or Nitrogen
Clean, moisture−free,
oil−free
5.0 SCFM (142 L/min)
Particulates to 5 microns
Air
100% at 30 Amps
30 VDC at .1 Amps
30 VDC at 1 Amp
torch
Safety trigger guard
Safety interlock devices shut
down power source
5/8 in.
3/16 in.
2.3 lb (1 kg)
8-3/4 in.
(222 mm)
1-1/2 in.
(38 mm)
−−
−−
−−
−−
90 PSI (621 kPa)
120 PSI (827 kPa)
Min
Max
−−
−−
−−
−−
−−
−−
− −
− −
− −
− −
−−
−−
−−
−−
−−
−−
− −
− −
Ref. 253 554-A