Burkert 8644 AirLINE Panduan Memulai Cepat - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Sistem Kontrol Burkert 8644 AirLINE. Burkert 8644 AirLINE 17 halaman.

There must be adequate space between valve block and pre-

decessor module > 6 mm.

→

Detach the modules/terminals from the standard rail according to

the manufacturer's description.

NOTE!

The interface of the left connection module contains elements

which may break off if force is used.

• Never place the valve block on its side and observe the permitted

installation position.

Fig. 9:

Detaching the modules/terminals from the standard rail

NOTE!

• When screwing the valve block back onto the standard rail,

observe a max. torque of 2 Nm!

Type 8644

Installation

INSTALLATION

7.1. Fluid Installation

DANGER!

Risk of injury from high pressure in the equipment!

• Before loosening lines or valves, turn off the pressure and vent

the lines.

• Design the connections with the largest possible volume.

• Close the open connections not required with lock screws.

• The connections for the pilot control exhaust air (x) must not be

sealed.

• Check correct assignment of the connections 1 and 3 or 5. They

may by no means be interchanged.

7.1.1. Pneumatic connections - feed

Fig. 10: Pneumatic Connections

Procedure:

→

Depending on the version, plug the connections in the corre-

sponding working connections or screw them in.

english

Exhaust air

X channel:

Standard version:

Deaeration of the control valves

Control assist air version:

P connection for control valves

Pressure supply connection