AQUAPHOR RO-31 Panduan Pemilik - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Penyaringan Air AQUAPHOR RO-31. AQUAPHOR RO-31 12 halaman. Drinking water machine
Juga untuk AQUAPHOR RO-31: Buku Petunjuk (17 halaman)

Halaman Cetak

3. INTRODUCTION

Aquaphor RO-31 (further referred to as "RO") manufactured by Aquaphor Corporation.

RO is designed for drinking water post-treatment from mechanical and colloidal particles, organic

impurities, bacteria, hard water components and other objectionable water impurities. RO eliminates

unwanted odors, flavors and discoloration of water, supplied by municipal and local water networks (water

from artesian water sources, wells, etc.), when meeting the requirements of this manual. RO materials are

safe, non-toxic and do not exude substances dangerous to human health and the environment.

4. DMW MAIN BLOCKS AND OPERATION PRINCIPLES

Collector blocks consist of housing, with three collectors fixed onto it, to replace the replacement cartridges.

Automatic valves have holes for wall mounting (fig. 1).

Figure 1

The water treatment block (1) pre-purifies and prepares the water for the membrane separation stage. This

block includes the replacement cartridge К5 (installed in the first position according to the water flow path) and

replacement cartridge К2 (installed in the second position). The preliminary water treatment block purifies water

from mechanical impurities, active chlorine, oil by-products, phenols, pesticides, chloroform and heavy metals.

Membrane cartridge (2). Here, water divides into two streams: purified water, ready for further treatment

and drain water, which includes unwanted impurities.

Clean water storage tank (3). When connecting the tip to the storage tank water will begin filling

the tank. After filling the tank, the float will rise and the water supply is automatically switched off and the

tip disconnects. If it is necessary to stop water filling earlier, just push the button located on the top of

the upper lid.

Web clipper (4). Designed for automatic water supplying disconnecting.

Water conditioning cartridge (5). Water conditioning cartridge (further referred to as "conditioning

cartridge") Aquaphor is designed for the correction of acidity (pH) and to enrich the water minerals to improve

the flavor and adjustments of the salt balance of drinking water.

5. RO* INSTALLATION

ATTENTION! To install, we recommend contacting our customer service department or an available

regional Aquaphor dealer.

ATTENTION! Before installation it is necessary to measure the incoming water pressure to your home.

If it exceeds 0,63 MPa (6,3 bar or 91.4 psi), install a pressure regulator with the waste-free operation

* Depending on the amount of impurities in the water, the service life (resource) of the water treatment cartridges may vary

(may be shorter or longer than the standard service life).