Aquaport AQP-TAP-4S Panduan Petunjuk Pemasangan & Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan & Pengoperasian untuk Produk Pipa Aquaport AQP-TAP-4S. Aquaport AQP-TAP-4S 14 halaman. Filtered water sink mixer 4 way tap

Halaman Cetak
D. Tubing Installation
The Tap has been supplied with quick and easy to install quick
connection pieces for your filtered water connection.
Note: Check the ends of the tubing to make sure there are no
cuts, nicks, flat spots or sharp edges. If any of these are present,
cut the ends with a utility knife. We recommend the use of a
tube cutter.
To install tubing:
Refer to section B. Typical Installation Diagram
1. Measure a length of 1/4" tubing to run from the filter head of
the filtration system to the Quick Connect T Piece.
2. Measure a length of 1/4" tubing to run from one outlet of
the Quick Connect T Piece to the tap Ambient Filtered Water
Connection.
3. Measure a length of 1/4" tubing to run from the other outlet of
the Quick Connect T Piece to the undersink chiller unit inlet.
4. Measure a length of 1/4" tubing to run from the outlet of the
undersink chiller unit to the tap Cold Filtered Water
Shank connection.
5. Measure 3/4 inch (19.05mm) from the ends of the tubing and
mark with a pencil. Fig 2.
6. Push the tubing firmly into the quick connection fittings on
the Filter System, Quick Connect T Piece and Tap connections
until the pencil mark is pushed next to the collet or until tubing
is fully seated, Fig 2. If tubing is removed, re-cut the end,
measure, mark and reinsert.
Note:
Tubing must be fully inserted/seated to avoid leaks.
7. Pull slightly on tubing to ensure tube is secure.
To remove tubing: push collet against the face of the fitting and
pull tubing to remove (with collet still held against fitting face)
Fig 3.
Fig 2
Fig 5 .
Fig 5 .
_"
Fig 5 .
3/4"
Correct Cut
Correct Cut
(1 9. 05m
19mm
m)
Incorrect Cut
Incorrect Cut
Insert tubing
Insert tubing
Fig 3
White collet, do
White collet, do
White Collet
not remove
not remove
Do Not Remove
3/4"
Insertion line
Insert 1/4"
_ "
Insertion line
_ "
Tube to Line
19mm
(1 9. 05
(1 9. 05
mm )
mm )
Engagement
Engagement
3/4" (1/4" Tubing)
3/4" (1/4" Tubing)
Push
Push Collet
Collet
Pull
Pull Tubing
Tubing
INSTALLATION AND OPERATING INSTRUCTIONS 7