Burley ENCORE Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kereta dorong Burley ENCORE. Burley ENCORE 12 halaman. Burley 2-wheel stroller kit
Juga untuk Burley ENCORE: Petunjuk Pemilik dan Manual Keselamatan (15 halaman), Brosur & Spesifikasi (5 halaman), Petunjuk Pemilik dan Manual Keselamatan (12 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Pemilik dan Manual Keselamatan (8 halaman), Petunjuk Pemilik dan Manual Keselamatan (20 halaman), Panduan Pemilik dan Keselamatan (8 halaman)

Halaman Cetak

II. Preparation for Installation

The Walk'n Roller requires the assembly and attachment of 3 components:

handlebar, parking brake, and stroller wheel. These are covered in sections III, V, and

VII. Each section has its associated part list so that you may conﬁ rm that you have

received all the parts needed. If any parts are missing contact Burley, do not proceed

with installation.

Tools Required:

7/16 inch wrench

Torque wrench

Extension

7/16 inch socket

Note: The No 2 Phillips screwdriver has a shaft diameter of ¼ inch or less

and is most useful here for making bolts holes through fabric. The No. 3

driver has a larger shaft (almost 1/3 inch) and is the better ﬁ t for tightening

the bolts of this assembly.

Left

Back

Right

III. Handlebar Installation

Parts included for the Handlebar Assembly:

(1) Padded handle with safety tether

(1) Roll Bar plastic replacement hinge

(1) Roll Bar plastic replacement catch

(4) ¼" locking nuts

(1) ¼ " jam locking nut (hinge)

Note: Standard nuts are larger width, across the hex and do not possess

a nylon locking ring. The locking nuts have a nylon ring built in. A jam nut

is thinner, requiring less height on the bolt. In assembly, when replacing

similar parts, use the new nuts provided.

No. 2 Phillips screwdriver

No. 3 Phillips screwdriver

Some adhesive tape

Front

(1) Handle Receiver –Right side

(1) Handle Receiver – Left side

(4) ¼" by 1-1/8" Phillips head bolts

(2) ¼ inch standard nuts

Burley Walk 'n Roller Manual; models 2003 and earlier

The locations of the Walk n' Roller

components are seen on the left.

#1 is the handle assembly, #2 is

the wheel assembly, and #3 is

the brake.

The directions around the trailer

are in reference to the normal

direction of motion, front being

forward.