Burley Tail Wagon Petunjuk Pemilik dan Manual Keselamatan - Halaman 7

Jelajahi secara online atau unduh pdf Petunjuk Pemilik dan Manual Keselamatan untuk Kereta dorong Burley Tail Wagon. Burley Tail Wagon 12 halaman. Burley 2-wheel stroller kit
Juga untuk Burley Tail Wagon: Brosur & Spesifikasi (5 halaman), Petunjuk Pemilik dan Manual Keselamatan (12 halaman), Petunjuk Pemilik dan Manual Keselamatan (9 halaman), Petunjuk Pemilik dan Manual Servis (12 halaman), Panduan Pemilik dan Keselamatan (8 halaman)

Removing Floor

For cleaning, floor may be removed by lifting at

front. Photo 10a Remove floor cover from base for cleaning

Reinsert floor rear under nuts in trailer rear and D-rings on

sides. In front corners, snap floor under front nuts. Photo 10b

Installing Safety Flag

Join pole sections together. On trailer's left side, insert flag

pole into flag receptacle on axle. DO NOT USE TRAILER

WITHOUT FLAG.

Operating Kickstand (Tail Wagon Only)

Use side knob to raise and lower kickstand.

Using Trailer as a Stroller (Tail Wagon Only)

Slide tow bar through both receptacles on left side. Line up

tow bar hole with rear receptacle hole. Insert retaining

front

pin through both holes and lock retaining hoop securely. Place

stroller wheel in the "STROLL" (down) position and tighten knob.

To adjust wheel tracking (which allows stroller to roll straight):

1. Loosen bolt using 5 mm hex wrench. Figure 1

2. With 25 mm (1") wrench, adjust bushing until wheel is

aligned and trailer tracks straight.

3. Tighten bolt.

NOTE: Stroller and kickstand

available as accessories for the Rover.

B U R L E Y P E T T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L