Chronomite CMT-4.0 Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Pemanas Air Chronomite CMT-4.0. Chronomite CMT-4.0 16 halaman. Electric mini tank water heaters
Halaman CetakELECTRICAL CONNECTIONS
Electrical Connections
To be certain that all of the air is out of the water heater, open the hot water faucet on your fixtures until
constant water flows from them. If air remains in the tank, the element will be damaged when the
electric cord is plugged in.
Connect the Water Heater to a Grounded Outlet.
The water heater is fitted with a power cord that is intended to plug into a grounded 110-120 VAC
receptacle. Adhere to all pertinent State and local codes. Install the correct size circuit breaker into the
master panel. The Chronomite water heater was manufactured and wired in accordance with UL
requirements.
The water heater is equipped with an overheat limiting device with a manual reset. Also known as the
temperature high limit, this device has been factory installed to interrupt the power supply in the event
of a thermostat failure. This water heater is designed for only 110-120V electrical service!
Do not connect to higher or lower voltage.
Failure to use proper voltage may result in personal injury and/or property damage. If the supplied
electrical power cord is either damaged or not long enough, do not use an extension cord. Have a
licensed electrician replace the power cord.
3100-010-001
10/17 REV 1
ELECTRIC TANK WATER HEATER - POINT OF USE
TOLL FREE 800-447-4962 • LOCAL 626-937-4270 • FAX 626-937-4279
Page 9 of 16
Chronomite Laboratories is a Member of Morris Group International™
CHRONOMITE TECHNICAL SUPPORT