ChronoRemoteControl SLH Series Manual Pemrograman - Halaman 3
Jelajahi secara online atau unduh pdf Manual Pemrograman untuk Kontrol Jarak Jauh ChronoRemoteControl SLH Series. ChronoRemoteControl SLH Series 3 halaman. Faac remote controls
Halaman Cetak5) Release the buttons and try your new remote control.
6) Perform a test of your new remote control.
Coding based on the receiver:
CAUTION: The coding operation will cause deprogramming remotes already in use
on this system.
1) Open the electronic cabinet of your motorization.
2) Press simultaneously the buttons P1 and P2 on the remote control already in
use and release them when the remote control flashes.
3) On the receiving card (RP, Decoder, Minidec), press and hold the self-
learning button so that the LED on the card flashes.
4) While holding down the self-learning key, press and hold a button on the
remote control until the LED on the receiver card stays on for 2 seconds.
5) Release all.
6) Wait 10 seconds before a trial run with your new remote control.
7) Close the radio receiver.
www.ChronoRemoteControl.com