Diamond BRIO43/X N Instalasi - Penggunaan - Pemeliharaan - Halaman 8
Jelajahi secara online atau unduh pdf Instalasi - Penggunaan - Pemeliharaan untuk Oven Diamond BRIO43/X N. Diamond BRIO43/X N 12 halaman. Electric fan ovens
Juga untuk Diamond BRIO43/X N: Instalasi - Penggunaan - Pemeliharaan (11 halaman), Instalasi - Penggunaan - Pemeliharaan (12 halaman), Manual (12 halaman)
Halaman Cetak
10. PROLONGED DISUSE
Before any prolonged disuse of the appliance,
proceed as follows:
- Clean the appliance thoroughly.
- Rub stainless steel surfaces with a cloth soaked in
vaseline oil to create a protective film.
- Shut off and main switches upstream of appliances.
Following prolonged disuse, proceed as follows:
- Inspect the appliance thoroughly before using it
again.
- Allow electric appliances to operate at the lowest
temperature for at least 60 minutes.
INSTRUCTIONS FOR CLEANING
IV.
11. REMINDERS FOR CLEANING
READ THIS MANUAL CAREFULLY. IT
PROVIDES IMPORTANT INFORMATION
FOR SAFE INSTALLATION, USE AND
MAINTENANCE OF THE APPLIANCE.
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR INJURY
RESULTING FROM FAILURE TO
OBSERVING THE FOLLOWING RULES.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, BEFORE CARRYING OUT ANY
OPERATION.
It is essential to have the oven cleaned on a daily
basis, with the machine temperature between 40
and 50° C. Carefully clean hinges – this is very
important – to avoid any future malfunctioning, in
door opening and closing.
Use only detergents, that are suitable for oven
cleaning; do not use these for grills, as they are too
aggressive and rich in caustic soda.
The use of any unsuitable compound can cause
oven component corrosion.
Do not clean the appliance with direct jets of water.
INSTRUCTIONS FOR
V.
MAINTENANCE
12. REMINDERS FOR THE MAINTENANCE
TECHNICIAN
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR INJURY
RESULTING FROM FAILURE TO
OBSERVING THE FOLLOWING RULES.
Identify the specific appliance model. The model
number is detailed on the packing and on the
appliance dataplate.
The appliance must be installed in a well-ventilated
room.
Do not obstruct any air vents or drains present on
the appliance.
Do not tamper with appliance components.
Installation and appliance maintenance must be
carried out by qualified technicians authorized by
the manufacturer, in compliance with current safety
standards and the instructions in this manual.
COMMISSIONING
See Chapter " INSTRUCTIONS FOR MAINTENANCE ".
VENTILATED OVEN
The appliance does not heat.
Possible causes:
- Temperature thermostat defective.
- Heating elements defective.
- Safety thermostat tripped.
Heating cannot be adjusted.
Possible causes:
- Temperature thermostat defective.
13. REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS
15