Aquasana OptimH2O AQ-RO-3 Panduan Pemilik - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Penyaringan Air Aquasana OptimH2O AQ-RO-3. Aquasana OptimH2O AQ-RO-3 14 halaman. Whole house water filter
Juga untuk Aquasana OptimH2O AQ-RO-3: Panduan Pemilik (11 halaman), Panduan Pemilik (10 halaman), Panduan Pemilik (16 halaman)
Halaman Cetak
1 - INSTALL BRASS TEE FITTING
i
Turn
off the cold
water
supply
to
the sink.
2
Turn on
the kitchen faucet
to
release pressure and allow
water to
drain from the line.
3 Disconnect
the cold
water
line from the 'A" threaded
stem on
the bottom of the kitchen
faucet. Attach threaded ends of supplied brass
tee to
the cold
water
supply line and shut-off
valve; tighten using
an
adjustable wrench.
4
Attach
%"
white tube
to
the brass
tee:
\
y
y
y
y
y
y
A. Slide
the compression
nut onto
the white tubing.
B. Slide
the plastic sleeve
onto
the white tube.
C.
Place brass
insert into
the opening of white tube.
D.
Push the tip of the white tubing
into
the opening of the brass
tee.
E. Slide
the
compression
nut onto
the threads of the brass
tee.
F.
While holding the white tube
in
place, tighten the
compression
nut to
compress
the plastic
sleeve and
create a
seal.
NOTE: Use a
wrench
to
ensure
complete seal. Avoid overtightening.
5
Do
not
connect
the other end
at
this
time.
3 - INSTALL WATER STORAGE TANK
On
the nipple
on top
of the tank, apply Teflon®
tape 4 or 5 times
clockwise around
in
the
same
direction
as
the threads.
Hand tighten the tank
connector onto
the tank
nipple until
secure. NOTE: Do not cross
thread
or
over
tighten.
Using
mount
stand, place tank
near
the
system
manifold.
Measure
3/8"
white tubing
to
the outlet
side of the
system
manifold and
ensure you
have enough tubing
to connect
tank and
system
manifold
as
well
as
enough left
to
attach faucet
stem
and remineralizer.
Cut
3/8"
white tubing.
1
2
to"
3
(§)