AquaScape 78224 Petunjuk & Pemeliharaan - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk & Pemeliharaan untuk Air Mancur Luar Ruangan AquaScape 78224. AquaScape 78224 12 halaman.
Juga untuk AquaScape 78224: Petunjuk & Pemeliharaan (6 halaman)

Halaman Cetak

Installation

STEP 1

SELECT AND MARK OUT THE AREA

• Select a location for the installation. Avoid

selecting a location that is an unused area of

the property. We recommend locations near

decks or patios, so it is easy to sit and relax

next to the water feature. If possible, make the

feature visible from a regularly used window

or patio door to provide enjoyment from both

inside and outside (Ex. 1).

• Set the AquaBasin

Then, using a can of brightly colored spray

paint, trace around the basin to outline the

area that is to be excavated (Ex. 2).

STEP 2

EXCAVATE, LEVEL, AND BACKFILL

• Using the traced area as a guide, dig the hole

roughly 1" deeper than the AquaBasin

(Ex. 3). The additional depth will allow the

basin to sit flush with the ground once gravel

is added.

in the desired location.

☎

US (866) 877-6637 |

• Use a soil tamper to properly compact the

soil. This will prevent any unnecessary settling

during or after installation.

• Place a level on the bottom of the excavation

to make sure it is level from side-to-side and

front-to-back. The base of the excavation

should be soil that is smooth, flat, and free of

lumps or debris. If existing soil conditions do

not meet these standards, add compactable

material such as sand to provide an

appropriate base for the basin.

• The AquaBasin

installing the Aquascape Compact Fill Valve

(not included) to automatically add water to

the feature when needed. If installing a water

fill valve, refer to page 6 for installation

instructions. Install the fill valve at this time.

• Place the AquaBasin

and use a level to make sure it is level from

side-to-side and front-to-back (Ex. 4).

Ex. 1

• If the basin is not level, remove it and correct

the excavation until the AquaBasin

• Thoroughly backfill the sides with sand or dirt.

This helps prevent any future shifting of the

Ex. 2

basin.

STEP 3

CONNECT

WATER

FEATURE

• The center

hole of the

AquaBasin

pre-drilled for

single-fountain

applications.

When installing a single fountain in the

center of the basin, use the center hole to

run the plumbing (Ex. 5).

Figure 3

Ex. 3

☎

CAN (866) 766-3426 | aquascapeinc.com

provides the option of

in the excavated hole

Ex. 4

sits level.

Ex. 5