Diamond 350/VCS-N Panduan Pengoperasian dan Pemeliharaan - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemeliharaan untuk Peralatan Dapur Diamond 350/VCS-N. Diamond 350/VCS-N 16 halaman.

CHAP. 7 - MAINTENANCE

7.1 - GENERALITIES

Before carrying out any maintenance operations it is necessary to:

a) disconnect the feed plug from the electrical network to completely isolate

machine from the rest of the system.

b) bring the graduated hand grip which regulates the thickness gauge to "0".

7.2 - BELT

The belt does not need to regulated. Generally after 3/4 years it must be

replaced, in this case call the "SERVICE CENTER".

7.3 - FEET

The feet could deteriorate in time and lose their elasticity, therefore decreasing

the stability of the machine. Replace them by calling the "SERVICE CENTER".

7.4 - FEEDING CABLE

Periodically check the state of wear and tear of the cable and call the "SERVICE

CENTER" for its replacement.

7.5 - BLADE

Check that the diameter of the blade, after many sharpenings, has not been

reduced more than 10 mm. compared to the original diameter. For its

replacement call the "SERVICE CENTER".

7.6 - GRINDERS

Check that the grinders continue to have their abrasive property during the

sharpening. When they are no longer abrasive they must be replaced as to not

damage the blade, therefore call the "SERVICE CENTER".

7.7 - SLIDING GUIDES LUBRICATION

Occasionally put a few drops of oil (from the tube that is provided) on the round

bar that the trolley slides back and forth on, through the hole (OIL) located on the

side of the graduated hand grip.

7.8 - PUSH-BUTTON PANEL LABEL

The push-button panel label can be marked and/or punctured with time. In such

a case call the "SERVICE CENTER" to replace it.

8.1 - OUT OF SERVICE

If for some reason it is decided to put the machine out of service, make sure that

it cannot be used by anyone: detach or cut the electrical connections.

8.2 - WEEE Waste of Electric and Electronic Equipment

Directive 2002/95/EC, 2002/96/EC and 2003/108/EC on the restriction of the use of

certain hazardous substances in electrical and electronic equipment, and waste

electrical and electronic equipment

This symbol, crossed out wheelie bin, on the product or on its packaging indicates that

this product must not be disposed of with your other household waste.

Separate waste collection of this appliance is organised and managed by the

manufacturer. It is the user's responsibility to contact the manufacturer and follow the

waste treatment system the manufacturer has adopted for separate waste collection.

The separate collection and recycling of your waste equipment at the time of disposal will

help to conserve natural resources and ensure that it is recycled in a manner that protects

human health and the environment.