AquaScape AquaSurge 4000-8000 Petunjuk & Pemeliharaan - Halaman 6
Jelajahi secara online atau unduh pdf Petunjuk & Pemeliharaan untuk Pompa Air AquaScape AquaSurge 4000-8000. AquaScape AquaSurge 4000-8000 20 halaman. Adjustable flow pond pump
Juga untuk AquaScape AquaSurge 4000-8000: Petunjuk & Pemeliharaan (20 halaman)
Halaman Cetak
Smart Control Receiver Setup
• Mount the receiver above the ground on a post, fence, or
wall.
• Connect the pump to the Smart Control Receiver.
• Plug the Smart Control Receiver into an outdoor-rated
GFCI, and the unit will automatically enter pairing mode
(Ex. 8).
NOTE: The blinking blue light on the face of the unit
indicates the receiver is in pairing mode and ready to be
connected.
• Download the Aquascape Smart Control App (available on
iOS or Android App Store).
• Open the Aquascape Smart Control App and click 'Create
New Account' (Ex. 9).
NOTE: If you already have an account, login with your
username and password.
• Once logged in, click the three dashes in the upper right-
hand corner of the home screen (Ex. 10).
• Click 'Add New Device' (Ex. 11).
• Enter the Wi-Fi network and password for the network to
which the unit will connect (Ex. 12).
Ex. 9
General Maintenance
• It is recommended to inspect your pump on a regular
basis to make sure it is functioning properly.
NOTE: Always disconnect the power before performing
maintenance on the pump.
6
Ex. 10
Ex. 11
NOTE: Adequate Wi-Fi coverage is required (2.4g
networks supported)
• Continue to follow on-screen instructions to complete the
pairing process.
• To reset the device to factory defaults, first turn the unit off
by pressing the power button, then press and hold the +
and - buttons for four seconds and release when the LED
display lights up completely (Ex. 13).
Ex. 8
• The receiver includes a switch that allows the pump to be
operated in the two following modes (Ex. 14).
Position 1 - Operated by Aquascape Smart Control
O
App or remote control
Position 2 - Bypass control, and operate at full
–
flow-rate
• In the event of a power loss the pump will revert to the last
flow-rate setting.
Ex. 12
Filter Screen Cleaning
• A filter screen clogged with debris will reduce the water
flow rate.
• Remove any existing debris from the outside of the filter
screen.
• In situations with excess debris build-up, the pump
screens will need to be removed for a more thorough
cleaning.
☎
☎
US (866) 877-6637 |
CAN (866) 766-3426 | aquascapeinc.com
Ex. 13
Ex. 14