AquaScape MicroSkim 99771 Instruksi dan Pemeliharaan - Halaman 6
Jelajahi secara online atau unduh pdf Instruksi dan Pemeliharaan untuk Sistem Penyaringan Air AquaScape MicroSkim 99771. AquaScape MicroSkim 99771 16 halaman.
Halaman Cetakdamage the threads on the nut
inserts when punching the holes
with the awl. Remove the awl or
nail while holding the faceplate
and liner in place and begin
threading one of the screws into
filter. Repeat this process for the
other screw. (See Ex. 10)
• Now remove the faceplate from
the skimmer, keeping the screws
installed through the faceplate
and liner. (See Ex. 11)
• Apply a bead of fish-safe silicone
sealant around the skimmer
opening, over the nut inserts.
Pre-installing the two screws in
the earlier steps will make it easy
to line up the skimmer faceplate
after the silicone is applied and
will keep the silicone in as thick
of a bead as possible.
(See Ex. 12)
• Replace the skimmer face plate
and the two corner screws and
then proceed with the bottom
two corners. Make sure the
holes in the faceplate that the
weir flap clicks into are on the
bottom. (See Ex. 13)
• With the 4 corners secured, you
may now punch the remaining
holes with your awl and thread in all the screws.
Again, be careful not to damage the threads on the nut
inserts.
• Let dry for at least one hour before introducing water.
• Insert the Filter Brush Cartridge and the Debri Net into the
MicroSkim
. See image below for placement.
®
6
Ex. 10
Ex. 11
Ex. 12
Ex. 13
MicroSkim
Filter
®
Filter Brush Cartridge
secures brushes
making it easy to remove for
cleaning
Large volume debris net
☎
US 1-866-877-6637 |
STEP 5
ADD ROCK AND GRAVEL
You can expect to use several tons of stone and gravel for
your water feature. Talk to your Aquascape retailer or rock
yard for help choosing the quantity and sizes of stone and
gravel. Visit www.aquascapeinc.com for information on
calculating the required stone and gravel. Below are some
helpful formulas for choosing the stone and gravel.
Stone Calculation for the Pond
Length x Width / 65 = Tons of boulders
Gravel Used in the Pond
Pond Gravel = 30% total tons of pond boulders
• Start from the bottom and set the largest character
boulders first against the vertical walls, then stack the
smaller boulders on top. (See Ex. 10 on pg.7)
• Be careful when placing any large boulders so you don't
damage the liner.
• The opening on the front of the MicroSkim
by placing boulders on either side and bridging a stone or
piece of driftwood across, creating a cave effect.
Note: Make sure the boulders do not block the water flow into
the skimmer.
• Cover all remaining flat surfaces with a couple inches of
decorative gravel. This will help lock the boulders in place,
as well as cover the remaining liner, protecting it from
ultraviolet rays, and giving bacteria a place to colonize.
☎
CAN 1-866-766-3426 | www.aquascapeinc.com
can be hidden
®