Panasonic WV-SP508 Panduan Instalasi - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Camcorder Panasonic WV-SP508. Panasonic WV-SP508 40 halaman. Ip video cameras
Juga untuk Panasonic WV-SP508: Spesifikasi (2 halaman), Panduan Instalasi (36 halaman), Catatan Integrasi (8 halaman)

Halaman Cetak
Panasonic WV-SP508 Panduan Instalasi

Lens mounting

Slowly rotate the lens clockwise to mount the lens and connect the lens cable to the ALC lens con-
nector of the camera.
ALC lens connector
Optional dedicated lens
Product name
ALC lens for 1/3 type CCD cameras
2x varifocal (High resolution)
* If a lens for 1/3 type video camera other than the above is mounted and the camera is used at
resolution of 1280 x 720 or higher, the camera cannot achieve full performance of high resolu-
tion. It is recommended to use a dedicated high-resolution lens especially when the illuminance
level of the photographic subject is low and the camera is used with the lens iris open.
How to adjust the focus
z
Before adjustment, reset the back focus position by holding down the auto back focus button
for 5 seconds or more when the power is on. (This operation can also be performed on the
setup menu. Refer to the Operating Instructions (included in the CD-ROM).)
x
Adjust the view angle and focus coarsely by adjusting the zoom and focus of the lens to center
a subject in the screen, and then press the auto back focus button on the side of the camera
(☞ page 16) or perform the auto back focus function from the setup menu.
Refer to the Operating Instructions (included in the CD-ROM) for how to perform the auto back
focus function from the setup menu.
IMPORTANT:
• Press the auto back focus button twice quickly to perform basic adjustments in a short time.
For more accurate adjustments use the detailed adjustments.
• After performing basic adjustments, make sure to press the auto back focus button once to
perform detailed adjustments.
18
Zoom lock knob
CS-mount lens
(option)
Focus ring
Model number
WV-LZA62/2
Protruded portion
from mount face:
ø20 mm {25/32
inches} or less
Protruded portion from flange face:
4.5 mm {5/32 inches} or less
1 3
Pin No.
1
2
3
4
2 4
Dump @
Dump !
Drive !
Drive @