Diamond Antenna SDC1 Petunjuk Pengoperasian - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Pengontrol Diamond Antenna SDC1. Diamond Antenna SDC1 2 halaman. Tuning controller for sd330

Halaman Cetak
●The SDC1 is not the water proof structure. Do
not get water to the product.
●Since the inside of the SDC1 is a complicated
electronic circuit, don't use it where is a strong
magnetic field or high temperature and
humidity.
●Since the dashboard of the car becomes high
temperature, don't install the product at the
dashboard.
・ Descriptions and Functions
①Display panel: The operation situation is shown.
change
②Frequency
operation frequency.
③GO button: To start the operation.
④UP button: To go the coil up. (To tune lower
frequency)
⑤DOWN button: To go the coil down. (To tune
higher frequency)
⑥RESET button: To stop the coil during moving
the coil.
⑦Power switch: To turn ON/OFF.
⑧Cigar plug: To connect with a cigar socket of a
car and to take power supply.
⑨Terminal for connection with the SD330: (The
terminal
is
different
production time. Please connect with a suitable
one.
・ Wiring and Connection
1200
8
To cigar socket
Miyata Building, No.15-1,1-chome Sugamo,Toshimaku Tokyo,Japan 170-0002 TEL.03-3947-1411 FAX.03-3944-2981
dial: To
change
depending
on
7MHz TUNING
7MHz = 1249
SD330 CONTROLLER
POWER
7
DOWN
RESET
5
6
DIAMOND ANTENNA CORPORATION
Home Page http://www.diamond-ant.co.jp
・ How to use the SDC1
1, Connect it as shown in below. Plug the cigar plug
into a cigar socket.
2, To turn the power switch ON, LED lamp turns on
and the current operation situation is shown on
the display panel.
3, Turn the frequency change dial and set the
operation frequency.
4, When pushing the GO button, the frequency and
"GO HOM POSITION" will be shown in the
display panel and the coil will be moved to the
lowest position. After that, the coil will be moved
to the selected frequency. The frequency and
position count number will be shown at that time.
5, When the coil goes to the selected frequency, the
the
coil will be stopped automatically. After stopping
the coil, please transmit at less than the output
10W. Adjust the SWR by UP/DOWN buttons.
(Since the antenna's conditions will be changed
depending on the surrounding condition, weather
and installation place. Please make sure to
check SWR.
6, To keep pushing the UP button, the coil will be
moved to the highest position and be stopped
moving. Since the internal motor will keep truing,
stop pushing the UP button at the earliest. After
that, to push the RESET button and push the GO
button, the coil will be moved to the selected
the
frequency.
7, If you want to stop the coil during operation, push
the RESET button. The coil will be stopped at the
position.
8, When you want to re-start the UP/DOWN
movement, go back to 3 or push UP/DOWN
buttons. The coil will be moved.
9, When operating 50MHz band, use the optional
element "OPE750".
800
SDC1
18
14
21
24
10
FREQ
7
28
UP
GO
3.5
50
off
4
SD330 Antenna
(not included)
9
1
The included cable
2
of the SD330
(not included)
3
To the SD330 Antenna