Diamond Audio Technology D7152 Panduan Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penguat Mobil Diamond Audio Technology D7152. Diamond Audio Technology D7152 11 halaman.

Halaman Cetak

CONTINUOUS RMS OUTPUT POWER

Note: Full Rated Power is generated at all voltages between 11 and 16VDC.

D7152

150W x 2 @ 4 Ohm Stereo

300W x 2 @ 2 Ohm Stereo

600W Bridged @ 4 Ohms

(minimum impedance)

CROSSOVER SPECIFICATIONS

Quantity:

2 (1 for CH 1/2 INPUT, 1 for X-OVER OUT)

Type:

Fully Independent and Selectable Highpass,

Lowpass, Bandpass or All-pass

Slope:

Third Order 18dB/Octave

Alignment:

Butterworth

FUSE RECOMMENDATIONS

D7 Professional Reference Series Amplifiers, by design, require external fusing.

Research has shown that a circuit board mounted fuse can create a drop in

available DC voltage at the input of the power supply resulting in increased

current draw.

We recommend that you install the correct size fuse/holder combination to the

main power cable within 18 inches of the battery. This will protect your vehicle

from fire damage due to a short circuit to the chassis or vehicle body. If a single

amplifier is installed, follow the fuse recommendation below. If installing

multiple amplifiers, add up the total fuse ratings of all installed amplifiers. This

should be used as your main fuse rating.

Amplifier

D7152

D7402

Note: A main fuse must be installed within 18 inches of the positive

battery terminal.

D7152 and D7402 manual #135.p65

D7402

400W x 2 @ 4 Ohm Stere

800W x 2 @ 2 Ohm Stereo

1600W Bridged @ 4 Ohms

(minimum impedance)

Maximum Fuse Rating

150

SYSTEM DIAGRAM 3

Two Channel System

Using a Three-Way Component Set

D7402 two channel amplifier

Channels 1/2 full range to a three-way component

set with passive crossovers

8/30/2002, 2:36 PM