Aquasub engineering ADP 07T Panduan Pengoperasian - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pompa Air Aquasub engineering ADP 07T. Aquasub engineering ADP 07T 15 halaman. Submersible dewatering pump. texmo adp series

Halaman Cetak

OPERATION PRECAUTIONS

Do not run the pump dry, it could lead to product damage.
Switch off the power supply and ensure the impeller fully stop, before
changing rotation or making any other adjustments.
Do not use this pump for hot liquids exceeding 40°C temperature, it may
lead to product failure.
Do not switch on the pump if there is any human contact with the pumping
water. If any electrical leakage occurs it could be harmful.

TRIAL OPERATION

The Submersible Dewatering pumps
are equipped with float switch which can
automatically switch "on" and "off" the
pump by sensing water level.
Trial operation can be done before installing
the pump in pit, by following below said
procedure,
1.
By default, float switch will be in
downward direction. In this position switch
on the pump, ensure that the pump is in
"off" condition.
2.
Move the float switch upward and
ensure that the pump starts.
3. Move the float downward and ensure
that the pump stops.
Repeat this procedure for 2 to 3 times and ensure that the pump is
working normally.
Ensure the free movement of float switch. Sump wall or any other structure
should not obstruct the free movement of float switch.
If you find any abnormalities like vibration, noise, smell etc.. in the pump
during trial operation, switch off the pump and contact the dealer where
this pump was purchased or the "AQUASUB ENGINEERING's" sales office in
your area.
ON
OFF