3Built RES12VLAB Panduan Petunjuk Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kontrol Jarak Jauh 3Built RES12VLAB. 3Built RES12VLAB 9 halaman. Remote engine shut-off

Halaman Cetak

PROGRAMMING

 NORMALLY-OPEN MODE. (Image #2)

This step must be performed if connecting as normally open.

When the Receiver is powered on, the relay is in a closed state (normally-closed) by default. Some ignition systems like the MSD Pro

Mag 12 need a normally-open relay operation. This method allows you to change the operation of the Receiver so that when the

Receiver is powered on, the relay is in an open state and does not allow electricity to flow.

1) Turn Receiver off and then back on to determine its current state. Check the Receiver LEDs immediately after power up.

The yellow LED will illuminate and the Red LED will flash to indicate normally-closed mode.

The yellow LED will illuminate and the Green LED will flash to indicate normally-open mode.

2) Turn Receiver and Transmitter off.

3) Turn Receiver ON and make sure the green or red LED is on to show Run or Off mode. Proceed to steps #3 & #4 within 30

seconds.

4) Press and hold the RED button on the Transmitter.

5) Turn the Transmitter ON via the toggle switch.

6) Continue to hold the RED Transmitter button for at least 15 seconds.

7) The Receiver's LEDs will blink to indicate mode change.

8) Release the red button on the Transmitter

9) Perform Step #1 in this section to confirm desired mode.

 STATUS CHECK MODIFICATION

Transmitter asks the receiver if it is in off or run mode every 30 seconds. This can be disabled, if desired.

1) Turn Receiver and Transmitter off.

2) Press and hold the green button on the Receiver.

3) Turn the Transmitter on via the toggle switch.

4) Continue to hold the green button for at least 10 seconds.

5) The Transmitter's LEDs will blink:

If the green LED blinks, the Receiver is in Status Check Every 30 Seconds mode.

If the red LED blinks, the Receiver will not check status every 30 seconds.

ADDITIONAL FEATURES



The Transmitter queries the Receiver on power-up, during every button press, and every 30 seconds. 30-second check is

optional; see Programming section.



The Transmitter will automatically power off after 6 hours of inactivity to conserve the battery. Turn off and on again to

reset.



Press the Green button to check range status without shutting off the vehicle

These instructions are subject to change without notice.

www.3Built.com

Technical Support:

[email protected]

Sales:

[email protected]

Limited Liability Company: West Hills, CA

9/30/19

or 818-574-5334

Firmware ver:6.1.19