Aquatec ocean e-vip Panduan Petunjuk Pengoperasian - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kursi roda Aquatec ocean e-vip. Aquatec ocean e-vip 16 halaman.

Halaman Cetak

Problem

Possible

causes

Button for emer-

Rechargeable bat-

gency lowering

tery is flat

does not function

Cable not insert-

ed all the way

Connection plug

board not at-

tached

Button is faulty

Seat frame is

Motors were

tipped

raised to different

heights

Carrying out a reset:

Press the following three buttons on the hand con-

trol simultaneously for ca. 3 seconds:

●

Red STOP button (5, fig. 12)

●

Forward button (3, fig. 12)

●

UP button (8, fig. 12)

A beep is heard while the three buttons are pressed.

When the indicator lamp "SERVICE" (6, fig. 12)

goes out, release the buttons. The device is ready

for use again.

Carry out a functional inspection. To do this, move

the chair in all directions.

Then lower the drive mechanisms for height ad-

justment to the lower end position until they audi-

bly disconnects.

Move the drive mechanism for the tilt adjustment

into the rear end position until it audibly discon-

nects.

Important!

If the error occurs again after reset, replace the

device or the faulty party and send them in.

Remedy

Recharge the bat-

tery (see

section 5.2) or use

a replacement

Insert cable all the

way

Attach the con-

nection plug board

(clicks in)

Carry out a reset

(see below)

Press the DOWN

button on the hand

control (2, fig. 12)

until the drive

mechanisms are

completely low-

ered and you hear

the click sound of

the end switch

Care and maintenance

Important!

●

Hygiene is especially important as regards

the toilet. Regularly clean the commode

and keep it clean.

●

This product can be disinfected. Choose

the disinfectant in accordance with AQUA-

TEC care guidelines. These are available

on request from AQUATEC.

●

Regularly check that the screws are firmly

fitted.

●

The commode is maintenance-free provid-

ed you follow the operating and care in-

structions. Regular, recurrent safety inspec-

tions are required.

7.1

Cleaning the seat frame and main frame

CAUTION!

There is a risk of injury from electric shock.

Before cleaning, close all caps and protect

all plugs.

Important!

●

Do not use abrasive cleaning agents.

●

Do not detach the holders for the accesso-

ries.

Close all caps and protect all plugs.

Take off any fitted accessories.

Pull the footrests out of the guides.

Take off the seat plate and the backrest cover.

Wash the individual parts with commercial deter-

gents (e.g. all purpose cleaning agents) using a

cloth or brush.

Rinse the parts under warm water.

Dry the parts with a cloth.

Reassemble the commode.

Important!

Clean the backrest cover at a maximum tem-

perature of 60 °C in a commercial washing ma-

chine.

CAUTION!

Burns

Let the commode cool down before touch-

ing it.

In clinics, in addition to the cleaning operations de-

scribed above, the commode should be cleaned at

regular intervals at 85 °C for 3 minutes in the auto-

clave.