Aquatec Beluga Petunjuk Perakitan - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Perakitan untuk Bantuan Kamar Mandi Aquatec Beluga. Aquatec Beluga 2 halaman. Change of actuator
Juga untuk Aquatec Beluga: Petunjuk Perakitan (4 halaman), Instruksi Perakitan (3 halaman), Petunjuk Perakitan (4 halaman)

Halaman Cetak
ASSEMBLY INSTRUCTIONS
Assembly of Headrest AQUATEC BELUGA
4.
WORK SAFETY:
It is imperative that you observe the accident prevention regulations of the tools and machines
used. In drilling the backrest take care not to injure your fingers. Use an underlay when drilling,
e.g. an old wooden board. Make sure the twist drill is at right angles to the surface.
Drilling diagram:
5.
ASSEMBLY:
1.
Screw the mountings (part 1) to the back of the backrest with the flat-headed screws (see
picture 1 below).
2.
Button on the backrest cover again.
3.
If not already pre-assembled, pull the headrest cover (part 4) over the bracket (part 3) and
fasten with Velcro fastener.
4.
Insert the bracket (part 3) into the screwed on mountings. (Assembly completed).
The height adjustment of the headrest to correspond to the size of the person is done by pulling
up or pressing down the bracket complete with cover (parts 3 and 4) in the mountings (part 1).
Picture 1 (from above)
Updated: 01.01.02/Marketing
16126 Assembly headrest Beluga
Page 2 of 2
V/Allgemein/Montage/Montageanleitungen/
Deutsch/Beluga/Montage Kopfstütze