Aquatec Equipment AQUAPRO 02AS512 Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Panel surya Aquatec Equipment AQUAPRO 02AS512. Aquatec Equipment AQUAPRO 02AS512 13 halaman. Solar panel & submersible pump kit

Halaman Cetak

ASSEMBLING THE FOUNTAIN KIT

• For the application of creating a small fountain, fit a selected nozzle and extension tubes on the top

of the pump outlet by pushing or screwing (depending on the model). There are different nozzles

for different fountain effects. To produce the fountain effect, it is best practice for the fountain

head or nozzle to be position 5 - 10cm above the water surface. It is best to keep the pump off the

waterfeature base to avoid drawing the waste and debris into the pump, otherwise it may lead to a

blockage in the pump. A household brick is sometimes used for this purpose.

• If you choose to connect tubing to the pump instead of the fountain kit, we recommend using one of

the riser stems from the fountain kit to push inside 13mm hose. You may need to utilize hot water to

soften the tube and expand the diameter to fit over the riser end. Remember to use Stainless Steel

hose clamps to fasten the hose on to the Hosetail. This is to ensure that the pipe does not blow off at

a later time or leak at this point in the plumbing system. Direct the hose in your desired direction.

• Place the pump in desired location. Ensure the pump is on a stable surface that is free of sludge,

sand and other debris. Do not place the pump directly on the water feature floor or in mud. It is

recommended to place the pump on a raised surface.

• Electrically connect the pump to the solar panel, and tighten the protection nut.

ASSEMBLING THE SOLAR PANEL

• Install the solar panel in garden lawn or soft ground by jabbing the spike (2) into the ground. Adjust

the orientation of the panel (1) to face the panel towards the sun and then tighten the screw on the

back of the panel to secure.

• Make sure to keep the pump (3) fully submerged in water while the pump is in operation.

• The solar pump should now operate.

AP300_960_1360 Instructions.indd 5

AP300SP / AP960SP / AP1360SP

SOLAR PANEL & SUBMERSIBLE PUMP KIT

A Q U A T E C E Q U I P M E N T . C O M

31/5/18 12:25 pm