HP 316095-B21 - StorageWorks Edge Switch 2/24 Catatan Rilis - Halaman 21

Jelajahi secara online atau unduh pdf Catatan Rilis untuk Beralih HP 316095-B21 - StorageWorks Edge Switch 2/24. HP 316095-B21 - StorageWorks Edge Switch 2/24 27 halaman. Edge switch release notes
Juga untuk HP 316095-B21 - StorageWorks Edge Switch 2/24: Manual Pembaruan (9 halaman), Manual (41 halaman), Manual (40 halaman), Catatan Rilis (32 halaman), Manual (26 halaman), Catatan Rilis (27 halaman), Catatan Rilis (25 halaman), Panduan Petunjuk Instalasi (24 halaman), Catatan Rilis (23 halaman), Catatan Rilis (23 halaman), Catatan Rilis (22 halaman), Catatan Rilis (23 halaman), Catatan Rilis (19 halaman), Catatan Rilis (19 halaman), Catatan Rilis (18 halaman), Petunjuk Manual (17 halaman), Catatan Rilis (17 halaman), Petunjuk Peningkatan (16 halaman), Petunjuk Manual (16 halaman), Panduan Petunjuk Instalasi (16 halaman), Catatan Rilis (16 halaman), Catatan Rilis (17 halaman), Catatan Rilis (17 halaman), Catatan Rilis (11 halaman)

Possible switch reset after power failure or power–down sequence

In extremely rare instances, after a power failure or power–down sequence, an Edge

Switch or Director conﬁguration may be reset to factory default settings. This is evident

when HAFM is unable to communicate with the Edge Switch or Director after being

powered on. This occurs because the IP address assigned to the Edge Switch or Director

has been reset to the factory default (10.1.1.10).

Workaround

If this occurs, the Edge Switch or Director conﬁguration and the IP address must be

restored. Also, all licensed features must also be reactivated by reentering the license

keys.

Activating very large zone sets may fail when using OSMS and CT_AUTH

If using third-party applications utilizing Open Systems Management Server with

CT_Authentication enabled, trying to activate a very large zone set may be rejected.

This will be ﬁxed in a future release of ﬁrmware.

Workaround

None.

Preferred Domain ID may not update automatically when conﬁguring

SANtegrity features

When conﬁguring SANtegrity, the Preferred Domain ID may not update automatically if

Enterprise Fabric mode or Fabric Binding are enabled and the switch is online.

Workaround

Enable Insistent Domain ID before enabling Enterprise Fabric mode, or make the

Preferred Domain ID the same as the active Domain ID.

Open Source software included in ﬁrmware (EOS) 8.x

The following Open Source software is included in ﬁrmware 8.x and later:

•

A) Secure Shell (SSH) 3.6.1p1—OpenSSH component provides a secure

alternative to the telnet server for Command Line Access (CLI) interface.

• BSD-like license is located at the following web site: http://www.openssh.org.

• Secure Shell (SSH) is fully embedded into EOS 8.x.

•

B) Secure Socket Layer (OpenSSL)—OpenSSL is used for secure connections

between switches.

• BSD-like license is located at the following web site: http://www.openssl.org.

Director and Edge Switch release notes