AQUATECH Steam Panduan Pengguna - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Dispenser Air AQUATECH Steam. AQUATECH Steam 6 halaman. Instant hot water dispenser
Halaman CetakSafety and warning notes
The device must be connected to reverse osmosis. The company will not be
responsible for limescale damage if the device is not connected to reverse
osmosis.
The installation of the device must be performed by a qualified technician
with the appropriate training
The device is intended for residential use only
The device must be connected to a standard earthed single phase electrical
outlet, 230V
The inlet water pressure must not exceed 2.5 bar
The indicator is lit only when the water is boiling
If the system does not produce water, check the system's power source
Do not clean the faucet with detergents and do not rub or scratch the
faucet.
Cleaning the faucet
Clean the faucet only with a damp cloth.
During an extended absence of 24H or more, the device must be
disconnected from the power supply
Keep out of the reach of children
The use of hot water must be under the responsibility and supervision of an
adult only
• Warning: The heating unit is connected to the drainage system in order to
remove excess water. Never touch and/or cancel this connection.
The use of the device is under the sole responsibility of the user.
Warranty of 12 months
To create the perfect solution, add
Aquachill and enjoy hot and cold water
with an extremely easy pouring!
[email protected] | www.aquatech.co.il | 1-800-686-686 | אקוואטק טיהור מים בע"מ
- 7 -
Installation Instructions
1. Read the installation instructions
carefully and follow them
Ensure that all the accessories
are supplied:
Steam device
Pouring pipe
Inlet pipe
Drain pipe
Installation screws (3)
Drain pipe clamp
Power supply cable
3mm drill bit
2. Install the faucet on the countertop
or the sink
Installing Steam
3. Place the attached drawing in the
desired location.
It is recommended to install the
device in a straight line with the
faucet.
The length of the pipe between
the device and the faucet shall not
exceed 40 cm.
4. Drill in the marked location using the
3 mm drill (supplied).
5. Fix the device with the supplied
screws.
6. Connect the pouring pipe to the
faucet.
7. Connect the drain pipe to the drain
Using the drain pipe clamp.
Warning: The drain hose clamp must
be installed above the syphon only!
8. Connect the inlet pipe to the water
supply (RO system).
9. Fill the device with water.
10. Pour 3 liters of tap water to flush
the system.
[email protected] | www.aquatech.co.il | 1-800-686-686 | אקוואטק טיהור מים בע"מ
- 6 -
11. Warning: The device must be
connected to the power supply
only after filling it with water and
flushing the system!
12. Connect the device to the power
supply.
13. The device will start heating
automatically.
Inspection after initial installation
1. Pour 3 cups of hot water and
ensure normal operation of the
system
2. Ensure the indicator light is on
during the heating process
Straight pouring pipe
Max. pipe length -
40 cm
Inlet pipe
Heating
indication LED
Drain pipe
Recommended Instalation Diagram