AQUATECH AxisGO Buku Petunjuk - Halaman 2

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Aksesori Telepon Seluler AQUATECH AxisGO. AQUATECH AxisGO 6 halaman. Smartphone imaging system

Halaman Cetak

Nomenclature

Initial Setup

Before using your AxisGO for the first time you

must conduct a water test as explained below. You

can perform the water test in any body of water that

allows submersion down to depths of 1-3ft. Make

sure the O-Rings are clean and dry before testing.

If the O-Rings or the AxisGO show any signs of

damage do not use. Replacement O-Ring kits can

be ordered through the website.

Make sure the O-Ring in fig 1. is present before

installing the port. Turning clockwise, screw in the

supplied lens port to the front of the AxisGO, align-

ing the threads of the lens port and AxisGO correctly,

to make sure there is

no cross threading. Do

not over-tighten the

port. Tighten so the gap

between the port and

body disappears.

Attach the included

Wrist Lanyard by tying

the tether to the leash

attachment point. Only

attach the leash to the

side hinge locations as

shown. It may be easiest

to install the leash with

the handle open.

Check the main O-Ring is located in its correct posi-

tion as seen in fig 2. and is in good condition.

Close the backplate and lock the side latch

by wrapping it around to the front locking

mechanism, and squeeze the latch down. An

audible 'click' should be heard to indicate the latch

is locked, and the latch release button should pro-

trude to its original position. Pull back firmly on the

side handle latch to ensure it has locked correctly.

Conduct a visual inspection of the AxisGO to be sure

a good seal has been created by checking that the

entire backplate has engaged well with the front

section, and there is no debris or other material

interfering with the sealing O-Ring. A small gap be-

tween the backplate and frame is normal.

Always use a Wrist Lanyard or leash when using

the AxisGO in any body of water as it is negatively

buoyant, therefore if it is dropped, it will sink.

Once the Wrist Lanyard is attached to your wrist you

can insert the AxisGO into the water.

Hold the AxisGO and immerse it into the water

for a period of 20 seconds.

Remove the AxisGO from the water, dry with a

towel and check that no water has penetrated

fig 1.

inside. Point the AxisGO up and check around

fig 2.