HP ProCurve J4864A Panduan Instalasi - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih HP ProCurve J4864A. HP ProCurve J4864A 38 halaman. Switch gl modules
Juga untuk HP ProCurve J4864A: Instal Manual (36 halaman)

Halaman Cetak

Connecting the Network Cables

Connect the appropriate network cables to the module's ports as shown in

the table below and on the next two pages. More detailed cable information

is included under "Cables" on

The cabling that you would use for the HP ProCurve Gigabit Transceivers that

are installed in the Gigabit Transceiver gl Module depends on the types of

transceivers you are using. Please see the manual that came with those

transceivers and the information in this manual on

the appropriate cabling.

Detailed information on cabling, especially the fiber-optic cabling used with

the Gigabit Transceivers and the mini-GBICs, can be found on the HP

ProCurve web site, http://www.hp.com/go/procurve. Click on Technical

Support and then faqs, and then select the product type.

Supported Cable Types

10/100-TX gl Module

�

��

�

��

�

��

twisted-pair cable

with RJ-45 connector

Notes:

• The RJ-45 ports on this module have the HP Auto-MDIX feature. In the module's default configuration, Auto, either

a straight-through or crossover cable can be used to connect the module to any other 100Base-TX or 10Base-T

device. See the Note on

• Since the 10Base-T operation is through the 10/100Base-TX ports, if you ever want to upgrade the ports to

100Base-TX, it would be best to cable the ports initially with category 5, or better, cable.

Module

�

��

RJ-45 ports with

"HP Auto-MDIX"

page

11.

Continued on the next page.

page

23.

Cable Type

10 Mbps operation:

category 3, 4, or 5,

100-ohm differential

��

twisted-pair cable

100 Mbps operation:

��

category 5, 100-ohm

��

differential twisted-pair

cable

Installing the gl Modules

page 23

for information on

Maximum Length

100 meters

(recommended)

100 meters