HP StorageWorks 8/40 - SAN Switch Catatan Rilis - Halaman 16
Jelajahi secara online atau unduh pdf Catatan Rilis untuk Beralih HP StorageWorks 8/40 - SAN Switch. HP StorageWorks 8/40 - SAN Switch 29 halaman. Hp storageworks fabric os 6.1.2b release notes (5697-0351, march 2010)
Juga untuk HP StorageWorks 8/40 - SAN Switch: Catatan Rilis (30 halaman), Catatan Rilis (43 halaman), Catatan Rilis (32 halaman)
Halaman Cetak
4
When routing to an M-EOS edge fabric using frame redirection, the M-EOS fabric must have a Fabric
OS-based product to configure the frame redirection zone information in the edge fabric.
5
HP recommends that M-EOS products operate with the most recent version of M-EOS released and
supported for interoperability. M-EOS 9.8.0 is the earliest version of firmware that is qualified to
interoperate with Fabric OS 6.1.1b or later.
4/256 SAN Director blade support
Fabric OS 6.1.x is fully qualified and supports the Director blades listed in
Table 4 4/256 SAN Director blade support matrix
Director blade
FC4-16
FC4-32
FC4-48
FC8-16
FC8-32
FC8-48
FC10-6
FC4-16IP (iSCSI blade)
FR4-18i (FCIP/FC Router blade)
DC Director blade support
Fabric OS 6.1.x is fully qualified and supports the DC Director blades listed in
Table 5 DC Director blade support matrix
Director blade
FC8-16
FC8-32
FC8-48
FC10-6
FC4-16IP (iSCSI blade)
FR4-18i (FCIP/FC Router blade)
16
Number of blades
Supported with any mix, and up to eight blades of each type. No inter-
mix restrictions. The 4/256 SAN Director must run Fabric OS 6.0.0b
or later to support the FC8-16 port blade, and Fabric OS 6.1.0a or
later to support the FC8-32 and FC8-48 port blades.
Up to four blades of this type
Up to two blades of this type. Up to eight FR4-18i blades can be
installed if they are used only for FC Fast Write or FCIP without routing.
Number of blades
Supported with Fabric OS 6.0.0b and later with any mix and up to
eight blades of each type. No intermix restrictions.
Not supported with the DC Director
Supported with Fabric OS 6.0.0b and later with a maximum of four
blades of this type. Up to eight FR4-18i blades can be installed if they
are used only for FC Fast Write or FCIP without routing.
Table
4.
Table
5.