HP StorageWorks XP12000 Panduan Konfigurasi - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Beralih HP StorageWorks XP12000. HP StorageWorks XP12000 34 halaman. Cache lun xp
Juga untuk HP StorageWorks XP12000: Catatan Rilis (13 halaman), Panduan Administrator (50 halaman), Panduan Konfigurasi (42 halaman), Panduan Konfigurasi (40 halaman), Panduan Konfigurasi (40 halaman), Panduan Konfigurasi (36 halaman), Panduan Konfigurasi (36 halaman), Panduan Konfigurasi (30 halaman), Panduan Konfigurasi (36 halaman), Catatan Rilis (5 halaman), Panduan Konfigurasi Sistem (49 halaman), Panduan Konfigurasi Sistem (43 halaman), Panduan Konfigurasi Sistem (42 halaman), Panduan Konfigurasi Sistem (35 halaman), Panduan Konfigurasi (46 halaman), Panduan Konfigurasi (46 halaman), Panduan Konfigurasi (40 halaman), Panduan Konfigurasi (44 halaman), Panduan Konfigurasi (38 halaman), Panduan Konfigurasi (30 halaman), Panduan Konfigurasi (30 halaman), Panduan Konfigurasi (42 halaman), Panduan Konfigurasi (50 halaman), Panduan Pengguna (30 halaman)

CAUTION:

Changing host group modes for ports where servers are already installed and configured is disruptive

and requires the server to be rebooted.

Setting the system option modes

The HP service representative sets the system option mode(s) based on the operating system and

software configuration of the host. Notify your HP representative if you install storage agnostic software

(such as backup or cluster software) that may require specific settings.

Configure the disk array Fibre Channel ports by using P9000 or XP Command View Advanced Edition

Software or XP Remote Web Console (shown). Select the settings for each port based on your storage

area network topology. Use switch zoning if you connect different types of hosts to the array through

the same switch.

In fabric environments, the port addresses are assigned automatically. In arbitrated loop environments,

set the port addresses by selecting a unique arbitrated loop physical address (AL-PA) or loop ID for

each port. For specific values, see the HP StorageWorks XP24000/XP20000 LUN Manager User

Guide applicable to your array.

Set each array port to FABRIC ON or OFF with connections of POINT-TO-POINT or FC-AL as shown

in the following table and figures. For detailed topology information, see the HP StorageWorks SAN

Design Reference Guide at:

http://www.hp.com/go/sandesign.

XP Disk Array Configuration Guide: Windows