HP Xw460c - ProLiant - Blade Workstation Panduan Pengguna - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Beralih HP Xw460c - ProLiant - Blade Workstation. HP Xw460c - ProLiant - Blade Workstation 33 halaman. Mezzanine card installation instructions for supported hp proliant c-class bladesystem servers
Juga untuk HP Xw460c - ProLiant - Blade Workstation: Panduan Pelaksanaan (35 halaman), Panduan Pencegahan Kesalahan (12 halaman), Buku Putih Teknis (12 halaman), Pembaruan Firmware (9 halaman), Panduan Instalasi (2 halaman), Panduan Pertanyaan yang Sering Diajukan (14 halaman), Poster Pengaturan (9 halaman), Panduan Instalasi (33 halaman), Panduan Manajemen (28 halaman), Manual Perangkat Keras (23 halaman), Ikhtisar (35 halaman), Panduan Pengoptimalan (13 halaman), Garansi Terbatas (10 halaman), Panduan Petunjuk Instalasi (10 halaman), Panduan Petunjuk Instalasi (8 halaman), Petunjuk Instalasi (4 halaman), Petunjuk Instalasi (2 halaman)

Microsoft® enables EMS support in the OS, but EMS support also requires

ROM support. EMS support, when enabled, assumes the serial port for

redirection and may cause interference with other devices attached to the serial

port. To avoid interference, EMS is disabled in the system ROM by default on

ML and DL servers. To enable this feature, Enable Local or Enable Remote must

be selected under the BIOS Serial Console/EMS Support menu in RBSU before

installing Windows® Server 2003. If you install Windows® Server 2003 with

EMS disabled, and later decide to enable it, perform the following steps to update

the boot.ini file:

1. Enable EMS in RBSU.

2. Run bootcfg/ems on/id 1.

3. Reboot.

Linux Red Hat 7 Serial Console Settings

If you are using an HP ProLiant BL e-Class server, each server blade maintains a

connection to COM 1, so they are primarily used remotely through the Integrated

Administrator. To enable BIOS Serial Console for Linux Red Hat 7 OS:

1. Remove the line:

2. Add the following line to the Linux image specification in /ect/lilo.conf:

3. Run /sbin/lilo to make the changes take effect.

4. Add the following line to the end of /etc/inittab to enable agetty on COM1

5. Set SAFE=yes in the file /etc/sysconfig/kudzu, so it does not probe the

6. Add the following line to /etc/securetty to allow root to log in on the ttyS0:

7. Reboot the server blade with these new settings.

HP BIOS Serial Console/EMS Support Settings and Configuration

message=/boot/message from /etc/lilo.conf

Append="console=tty0 console=ttyS0, 115200"

(ttyS0):

7:12345:respawn:/sbin/agetty 115200 ttyS0 vt100

serial port during initialization.

ttyS0