Panasonic U-20ME1E81 Panduan Petunjuk Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kamera Digital Panasonic U-20ME1E81. Panasonic U-20ME1E81 25 halaman. Wall mounted (k1 type), mini vrf (le1 type), 2way vrf (me1 type), 3way vrf (me2 type)
Juga untuk Panasonic U-20ME1E81: Panduan Referensi Cepat (24 halaman), Panduan Petunjuk Pengoperasian (26 halaman), Panduan Petunjuk Pengoperasian (25 halaman), Panduan Instalasi (9 halaman), Panduan Petunjuk Instalasi (28 halaman), Panduan Petunjuk Pengoperasian (10 halaman)

2. SELECTING THE INSTALLATION SITE

AVOID:

● areas where leakage of flammable gas may be expected.

● places where large amounts of oil mist exist.

● direct sunlight.

● locations near heat sources which may affect the

performance of the unit.

● locations where external air may enter the room directly.

This may cause "condensation" on the air discharge ports,

causing them to spray or drip water.

● locations where the remote controller will be splashed with

water or affected by dampness or humidity.

● installing the remote controller behind curtains or furniture.

● locations where high-frequency emissions are generated.

DO:

● select an appropriate position from which every corner of the

room can be uniformly cooled.

● select a location where the ceiling is strong enough to

support the weight of the unit.

● select a location where tubing and drain pipe have the

shortest run to the outdoor unit.

● allow room for operation and maintenance as well as

unrestricted air flow around the unit.

● install the unit within the maximum elevation difference

above or below the outdoor unit and within a total tubing

length (L) from the outdoor unit as detailed in the installation

manual packed with the outdoor unit.

● allow room for mounting the remote controller about 1 m off

the floor, in an area that is not in direct sunlight or in the flow

of cool air from the indoor unit.

● If the indoor unit is installed on the ceiling where the

temperature or humidity inside is high (over 30°C/RH: 70%),

add insulating material to the surface of the unit to avoid dew

condensation.

25 cm

Fig. 2-1