Panasonic WVBP550 - CCTV CAMERA Panduan Petunjuk Pengoperasian - Halaman 31
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kamera Digital Panasonic WVBP550 - CCTV CAMERA. Panasonic WVBP550 - CCTV CAMERA 36 halaman. Super dynamic dsp b/w cameras
Juga untuk Panasonic WVBP550 - CCTV CAMERA: Spesifikasi (2 halaman)
Halaman Cetak
6. To raise detection sensitivity, press
the MOTION DETECT menu.
7. To obtain the optimum detection level, move the
"I" cursor to adjust the level.
8. Repeat the procedures above to obtain a satisfac-
tory setting.
9. Move the cursor to RET and press
the CAM SET UP menu.
Notes:
• Masking or adjusting the detection level is needed
to prevent malfunction under the following condi-
tions:
• When shooting an object under flickering fluores-
cent light or shooting in ELC.
• When leaves or curtains etc. are swayed by the
wind.
• When the object is lighted by lighting equipment
that constantly turns on and off.
• It takes about 0.2 seconds for the alarm signal to
reach the alarm terminal of the VCR after the cam-
era detects the object.
Because the alarm signal is multiplexed on the
video signal, it may be mistakenly interpreted by
other video equipment as a time code signal.
Therefore, when camera is not used in a
Panasonic Intelligent CCTV System select OFF to
prevent the above from occurring.
8. Lens Drive Signal Selection (LENS
to return to
DRIVE)
This item is used to select the type of auto iris lens
drive signal to be supplied to the lens from the auto iris
lens connector.
to return to
1. Move the cursor to the LENS DRIVE parameter.
2. Select DC if you are using the auto iris lens that
requires a DC drive signal.
Select VIDEO if you are using the auto iris lens that
requires a video drive signal.
-29-
** CAM SET UP **
CAMERA ID
OFF
ALC/ELC
ALC
SHUTTER
---
AGC
ON
SENS UP
OFF
SYNC
INT
MOTION DET
OFF
LENS DRIVE
DC
END
SET UP ENABLE