Diamond Systems Athena III Panduan Pengguna - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat Keras Komputer Diamond Systems Athena III. Diamond Systems Athena III 14 halaman. Panel i/o board

Halaman Cetak

POWER SECTION

The power section provides the means to bring power to the system. The schematic below indicates the power

routing between the input power connector and the Athena III SBC through the panel I/O board. Power may be

provided in several methods:

1. +5V in from the input power connector directly to the panel I/O board, using either the front panel switch

or a direct connection, and then the Athena III SBC through the SBC's input connector.

2. Vin (8-30VDC) from the input power connector to a connector leading to an internal DC/DC power supply,

whose output is driven directly onto the PC/104 bus using the PC/104 bus connectors on the DC/DC

power supply. The Vin may be routed to the power supply connector either through the front panel switch

or through a direct connection.

3. Same as #2 above, except the +5VDC and optional +12VDC outputs of the DC/DC power supply are

routed back to the panel I/O board and then connected to the Athena III SBC through the SBC power

input connector.

The switch bypass jumpers are 0-ohm ¼ watt T/H resistors. To use the panel power switch, the resistor is cut

away, opening the circuit.

The +12V input option jumper is also a 0-ohm ¼ watt T/H resistor used to route +12V from the Vin pin to the +12V

pin on the Athena III power connector. If the Vin voltage is not +12V then the resistor is cut away to isolate the

+12V pin on the Athena III primary power connector.

PC/104™ is a trademark of the PC/104 Embedded Consortium.

All other trademarks are the property of their respective owners.

Athena III Panel I/O Board User Manual Rev A

www.diamondsystems.com

Page